Canon PIXMA MX712 Installatiehandleiding - Pagina 20
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Canon PIXMA MX712. Canon PIXMA MX712 23 pagina's. Guide for printer setup for network [spanish version]
Ook voor Canon PIXMA MX712: Aan de slag handleiding (4 pagina's), Fax Setup (2 pagina's), Specificatie (2 pagina's), Aansluithandleiding (6 pagina's), (Engels) Configuratiegids (23 pagina's)
Pagina afdrukken
An Unknown Access Point is Displayed
Access points in use nearby may also be detected.
The Access Point Name is Not Displayed Properly
Access point names with double-byte characters are not displayed properly. However, they can be selected.
The Access Point Name is Not Displayed Automatically
Refer to the manual supplied with the access point or contact its manufacturer.
WPA/WPA2
Failed to connect to the access point. Check the access point settings and try again.
Make sure that the passphrase entered for the access point is correct.
If the problem is not resolved, there may be other causes.
See also the sections below:
If the DHCP function of the access point is inactive, enable the DHCP function and confi gure wireless connection
settings again.
For details on how to check or change the settings of the access point, refer to the manual supplied with the access
point or contact its manufacturer.
WLAN setting list
If the MAC address fi ltering is enabled on the access point, change settings so that the MAC address of the printer
will be accepted.
Follow the procedure below to check the MAC address of the printer.
1. Press the MENU button.
2. Select Setup, then press the OK button.
3. Select Device settings, then press the OK button.
4. Select LAN settings > Confi rm LAN settings > WLAN setting list to check MAC address.
For details on how to change the settings of the access point, refer to the manual supplied with the access point or
contact its manufacturer.
If the problem is not resolved, there may be other causes.
See also the sections below:
If the access point is confi gured to communicate using IEEE802.11n standard only and TKIP is set as the encryption
standard, change the encryption standard to something other than TKIP or change the communication standard to
something other than IEEE802.11n, then confi gure wireless connection settings again.
If the encryption standard is set to TKIP, IEEE802.11n cannot be used as the communication standard.
For details on how to change the settings of the access point, refer to the manual supplied with the access point or
contact its manufacturer.
The Passphrase is Not Displayed Automatically
Refer to the manual supplied with the access point or contact its manufacturer.