Astralpool QG50 Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Astralpool QG50. Astralpool QG50 16 pagina's. Robotic pool cleaner
Pagina afdrukken
8
Section 4. General Cleaner Operation
CAUTION
To prevent damage to the cleaner, be sure to adhere
to the following guidelines:
•
Remove the cleaner from the pool after the cleaning
cycle is completed.
•
Store cleaner out of direct sunlight or inclement
weather.
•
Never lift the cleaner out of the pool by the floating
cable.
•
Take additional care when lifting the cleaner out of
the pool. It becomes heavier when filled with water.
•
Always remove the cleaner from pool before super
chlorinating or adding acid.
•
Do not handle cleaner while it is in operation.
IMPORTANT
•
Always make sure the cleaner head is fully
submerged before you begin operation.
•
Clean the filter canister after each cleaning cycle.
•
Do not leave your cleaner in the pool on a
permanent basis.
•
At the end of each cycle, remove the cleaner from
the pool.
•
Start at the cleaner head and untangle any coils in
the cable before storing the cleaner.
The QG50 robotic cleaner includes a safety feature
that automatically stops the cleaner if it is powered
on but not submerged in water. For pools equipped
with a beach area, this safety feature is programmed
to drive the cleaner in reverse and back into the pool
when the impeller is out of the water.
4.1
Install and Submerge the Cleaner
1.
With the control box plugged into a GFCI outlet,
spread the floating cable across the pool deck until
you reach the middle of the pool length.
2.
Submerge cleaner vertically (1) and hold it under the
surface, moving gently from side to side (2) until the
bubbles stop to remove any air trapped inside
(Figure 12).
3.
When the bubbles stop, allow the cleaner to sink to
the bottom of the pool.
4.
Verify the cleaner is sitting on the bottom of the pool.
Remove additional air if the cleaner is still floating.
QG50 robotic cleaner
1
Figure 12. Submerge and Remove Trapped Air
5.
Place the cleaner in the pool at the recommended
entry point (see Figure 4). Spread all of the floating
cable carefully in the pool, ensuring there are no kinks
or coils.
NOTE: For optimal patterning and reduced tangling, the
floating cable should enter the water near the
middle of the pool length (see Figure 13).
cleaner
cleaner
Figure 13. Pool Entry Point for Optimal Patterning
owner's Manual
2
Not
Recommended
Control Unit
Recommended
entry point
WARNING: Do not use
an extension cord