Cognex 3D-A5060 Hardware referentiehandleiding - Pagina 9

Blader online of download pdf Hardware referentiehandleiding voor {categorie_naam} Cognex 3D-A5060. Cognex 3D-A5060 19 pagina's.

Hardware Installation

Cognex ships your 3D-A5000 sensor with a power supply and cables for the GigE Vision cameras and I/O connections.

See the section

PC Requirements on page 6

Be aware you need the following accessories to complete the installation of your PC and 3D-A5000 series sensor:

A 1024 x 768 display at 96 DPI

Any network cables to connect your PC to your corporate network

A VisionPro security key.

The security key provides a security mechanism to ensure that the Cognex software is properly licensed.

(Optional) Hardware trigger

A mounting option for your 3D-A5000 sensor.

Refer to the following diagram for physical dimensions (in mm) of the mounting options on the back of the sensor:

To reduce the risk of injury or equipment damage, observe the following precautions when you install the Cognex

product:

Route cables and wires away from high-current wiring or high-voltage power sources to reduce the risk of

damage or malfunction from the following causes: over-voltage, line noise, electrostatic discharge (ESD), power

surges, or other irregularities in the power supply.

Changes or modifications not expressly approved by the party responsible for regulatory compliance could void

the user's authority to operate the equipment.

Ensure that the cable bend radius begins at least six inches from the connector. Cable shielding can be

degraded or cables can be damaged or wear out faster if a service loop or bend radius is tighter than 10X the

cable diameter.

This device is certified for office use only and if used at home, there can be frequency interference problems.

This device should be used in accordance with the instructions in this manual. Failure to do so may impair the

performance and/or protection provided by the device.

All specifications are for reference purposes only and can change without notice.

for the minimum PC requirements to use with your 3D-A5000 sensor.

Hardware Installation