Flycam HD-5000 Gebruiksaanwijzing - Pagina 14
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Flycam HD-5000. Flycam HD-5000 16 pagina's. Video stabilizer
Ook voor Flycam HD-5000: Gebruiksaanwijzing (11 pagina's), Montagehandleiding (10 pagina's)
Pagina afdrukken
You'll get one movement that's too slow and then you'll add a pair and it will fall too fast.
When that happens, take off the last pair of weights that you added.
Tighten down the weights so they don't slide around.
To get the perfect count, slightly lower Central Post that attaches the Base Platform with the
weights, until you get the 'one-one thousand, two one thousand' count to vertical
Fine-tune the left-right, forward-backward balance. You will have to go back and forth
between the two directions to get the balance just right. Loosen the screw sets that allow the
sled to move left and right. Adjust the top plate so that it is centered and tighten down the
screws.
Repeat for forward-backward balancing.
Check to see if your camera is sitting level. If not, repeat the necessary steps until it does.
Practice walking movements ensuring your body motion is not transmitted to your hands and
then to stabilizer and camera.
Holding your Flycam Stabilizer
When handling your Flycam 5000 Stabilizer, one hand holds onto the handle while other is used
to gently guide the camera in direction you wish to shoot and frame shot. For normal shooting,
hold the handle in middle.
For normal shooting, hold the handle in middle.
For shots that require framing the camera up, down or sideways, hold the handle firmly at
bottom.
This will allow the yoke part of gimbal to rotate without hitting your hand or knuckles.
Maintenance
Bearing Maintenance:
inches from top. It is of metal construction and partially enclosed by bearing assembly. If after a
period of time your bearings don't turn smoothly, lubricate with a minimum quantity of light
lubricating oil. It can also be used on the Yoke and Handle Bearings. Be sure to keep oil away
from your camera, & clean up any over spill.
Cleaning:
Do not use solvents or harsh cleaners of any kind on your stabilizer. If the unit
becomes dirty, use a damp soft cloth or sponge with mild detergent to gently clean external
parts.
Storage:
Should you need to store your Flycam 5000 stabilizer for a long period of time, then
place the unit upright in a dry or low-to-normal humidity area whenever possible. If you are
unable to find this kind of environment then we suggest you store the unit in an airtight plastic
bag. Standing the unit upright is preferred as it alleviates stress on the system.
The main bearing on stabilizer is attached to Central Post about two
14
position.