Akw Onyx Exclusif Handleiding voor installatie-instructies - Pagina 5

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Akw Onyx Exclusif. Akw Onyx Exclusif 8 pagina's. Shower tray

Pagina afdrukken

position the tray over the desired

location for the shower and outlet

pipe. mark around the edge

of the shower tray.

220 mm

355 mm

the waste area must be supported

with additional noggins, 220 mm

around the waste. additional

noggins or joists must be used on

all tray edges and between joists

centres at a minimum of 355 mm.

apply grab adhesive to all the

contact points between the tray,

joists and noggins. lower the tray

over the waste position and firmly

secure the tray into position and

check all 4 sides are level again.

Order: 01905 823 299

orders.akw-ltd.co.uk

Wooden Floor Installation

For 'in' floor installation, cut into

the flooring, taking care not to cut

through supporting joists or any

plumbing or electrical wiring.

220 mm

355 mm

Install the waste drain trap and

waste outlet pipe. Do not cut into

the joists, always drill through

when connecting to

the waste outlet pipe.

attach the waste trap to the tray

with the waste clamping ring, see

separate waste instructions.

apply a waterproof membrane to

the whole of the showering area,

see manufacturers instructions.

Carefully remove the floor boards

and locate the waste outlet pipe.

For 'on' floor installation, remove

the floor boards around

Water test the waste drain trap for

flow and any leaks. Ensure that the

rubber seal is in place.

remove any debris and ensure

that there are no sharp edges or

raised areas and check levels.

Safety flooring or tiles should finish

flush up to the edges of the tray

and sealed with sealant. protect

the waste trap from debris

Technical Support: 01905 560 219

the waste area.

during installation.