AIR GIZMOS Panel Dock 695 Installatie-instructies

Blader online of download pdf Installatie-instructies voor {categorie_naam} AIR GIZMOS Panel Dock 695. AIR GIZMOS Panel Dock 695 2 pagina's.

The Panel Dock has been shipped with a set of mounting hardware necessary for attaching it to an avionics

stack. If you intend to install it in a different way, use the included hardware as a reference when deciding what

type of installation hardware you will need. The hardware included is as follows:

4 AN525-832R8 SCREWS WITH INTEGRAL WASHERS, 4 AN960-8 FLAT WASHERS, and 4 MS35214 6-32 BLACK INSTRUMENT SCREWS.

A word of caution: we have designed the mount to be installed using standard screws, and we have fabricated

the flanges to allow clearance of the screw heads. Please do not attempt to use countersunk screws. Counter-

sinking plastic is generally not a good idea, and we cannot guarantee that our product will perform its duty if

you choose to countersink the holes. Also, please don't use Loctite®, or similar adhesive products for additional

security the screws, it will have a negative effect on plastic. Use the included hardware, or something similar,

and everything will be fine. Let's get started.

Step 1:

Prepare a hole in your panel

Step 2:

Temporarily attach mounting rails to the Panel Dock

Step 3:

Test-fit the Panel Dock

1100 Jupiter Road, Suite 110, Plano, TX 75074 • (972) 671-8001 tel • (972) 231-3870 fax

Installation Instructions for 695/696 Panel Dock

Revision 4, March 30, 2018

INST-A_90020129-001

Thank you for purchasing an AirGizmos Panel Dock. This mount was designed to

securely hold your portable electronic device. It allows you to quickly remove your

portable device from your plane for upgrades, flight planning, or for use in your car

or boat. We also feel that this is a safer way to use your portable equipment, as it

is securely held in the panel at all times. We hope you receive years of enjoyment

from our product. Before beginning the installation process, please take a moment

to fill out the registration card.

The dimensions of the 696 Panel Dock are included for reference, but measure

yours just to be safe.

Note: if you are installing this product with Garmin avionics, you will find that

Garmin uses 6.3" wide trays. To account for the difference it is acceptable to use

washers. One thin washer on each bolt will work just fine.

These instructions assume that you are installing the 696 Panel Dock in a standard radio

stack, but that is not the only way to install it. The only requirement for installation is that

you must attach the side flanges to two pieces of angle, spaced the correct distance apart.

Two pieces of 1" 6061 aluminum angle works just great. Position your rails as desired,

making sure they are the proper distance apart, and parallel to each other. You can rivet

the rails to the front panel or choose to attach the rails by aircraft quality hardware. Either

method works great.

Position the 696 Panel Dock in your panel. This will allow you to determine how it should

look from the front before you drill any holes. At this point you should make any adjust-

ments to the rails in order to have your GPS properly positioned in the panel.

4 AN365-832A ELASTIC LOCK NUTS,