ASTRO-MED Dash 16u Snelstarthandleiding - Pagina 3
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} ASTRO-MED Dash 16u. ASTRO-MED Dash 16u 13 pagina's. Field and lab recorder
Pagina afdrukkenCOLOR DISPLAY
ENCODER WHEEL
ALPHANUMERIC KEYPAD
SPEED CONTROL
AMP KEYS
RUN / HALT KEY
OPERATION HOTKEYS
3. FRONT PANEL CONTROLS
The color display is divided into four areas. Most of the display is used to show
the waveforms and grids. The area above and below the waveform display is
used for text related to menu items. On the right of the display is the menu
display area. This menu display area uses the ten menu display keys immediately
to the right of the color display.
The color display is used for real-time as well as data capture viewing. When
you make your choices using the menu display keys, the bottom part of the
display reports your settings as well as highlights the active choice.
Because the Dash 16u is versatile, where many choices are available, an encoder
wheel is used to quickly move through the selections. An example is gain setup
where the wheel is used to select your range and offset. Also, the encoder wheel
is used for moving the cursors when reviewing data.
A full QWERTY alphanumeric keypad is used for chart annotation (upper and
lower case), user scaling (engineering units), and setting up the gain of the
channels (range and offset).
There are eight buttons for speed control. Four buttons give quick selection of
common speeds: [1], [5], [25], [50]. Three other buttons to select the rate:
[HR], [MIN], [SEC]. The last key is the [SPD] key used to adjust the paper
speed, data logger (numeric) speed, select internal or external motor source, the
speed of the display (normal or trend) and to adjust the chart speed (+/- 2%).
Eight keys, one for two channels. For example, the first amp key toggles
between amplifiers 1 & 9. Set full scale range, offset (zero offset) from the
center of the channel, ground or unground the channel, select peak-to-peak or
RMS, setup filter, assign engineering units. Selecting the amplifier type, setting
the attenuator range and calibration are here as well.
Used to start and stop the chart paper real-time recording.
[HELP]
Three levels of help.
System Report:
Chart Report:
General Help :
[FEED]
Advances the chart paper as long as this key is pressed.
[ID]
Puts the channel number next to the waveform on the chart and
display. This key is useful with overlapping channels.
[MARK]
Toggles the system event marker located underneath the system log
on the chart.
[ARM]
Used to activate the data capture mode. Works with or without the
chart paper running.
[TRIG]
Manual trigger for data capture.
Amplifier, data capture and triggering settings.
Grid settings for all four charts.
Quick overview of Dash 16u functions.