FlyingFoam Nurf Algemene montage-instructies - Pagina 10

Blader online of download pdf Algemene montage-instructies voor {categorie_naam} FlyingFoam Nurf. FlyingFoam Nurf 11 pagina's.

Final Assembly

46. Lamination film will hold plastic compatible paint very well. You can also use trim

tape and/or colored packing tape to add color to the design.

NOTE: To maintain visual line of site and proper orientation it is highly recommended to

use a very high contrast color scheme.

47. Install your motor, speed control and receiver per the manufacturer's instructions.

For your maiden flight we recommend replacing any expensive cameras or similar

equipment with ballast; once the plane is properly tested and trimmed you can replace

the ballast with your real equipment and have fun.

48. Plug in the ailerons and install the wing and check for proper travel and direction.

Aileron

Elevator

49. To check the center of gravity you can use a tube or rod (a pencil works) under the

fuse as a balance bar, or the tips of your fingers just behind the leading edge of the wing

where it meets the fuse.

NOTE: Since the Nurf is a flying wing it has a fairly tight CG range and it is much easier

to maiden with the CG at the leading edge of the wing. You can slowly move the CG

back as you get comfortable with the plane.

Maiden Flight

NOTE: It's beyond the scope of these assembly instructions to teach you how to fly.

Please adhere to AMA safety regulations, use common sense and have fun.

50. During the maiden flight we recommend that the plane be trimmed so that you can

fly straight and level at half throttle from one side of the field to the other without pilot

corrections.

Rev 2.0 10/21/13

Low

1/4 - 3/8

High

1/2 – 3/4

1/2 - 3/4