Air Gunsa AZ30 HTE 1.8 Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Air Gunsa AZ30 HTE 1.8. Air Gunsa AZ30 HTE 1.8 4 pagina's. Spray gun az30 hte m&s cup

Pagina afdrukken

SPARE PARTS LIST

M&S CUP 600 cc
31
30
Akulon CUP 600 cc
29
20-1
20
28
27
26
6
SPARE PARTS LIST
Description
AIR CAP
NOZZLE HOLDER
TRIGGER STUD
PATTERN ADJUSTMENT
COMPLETE AIR VALVE
AIR VALVE SHAFT
AIR VALVE SET
AIR VALVE SPRING
AIR VALVE SPRING SEAT
FLUID ADJUSTMENT GUIDE
FLUID NOZZLE
FLUID NEEDLE
NEEDLE PACKING NUT
SCREW
TRIGGER
FLUID NEEDLE ADJ. KNOB
NEEDLE SPRING
THREADED BUSHING
PACKING SET
AIR CAP PACKING SET
AIR FLOW CONTROL VALVE
Akulon CUP 600 cc
CUP SET
LID SET + NON DRIP
FILTER
M&S CUP 600 cc
CUP HOLDER
FILTER
INNER LID
CUP
KNOB
RING
NOTE:
When ordering parts, specify gun's model, part name with ref.No.
and marked No.of air cap set, fluid nozzle and fluid needle.
OTHER PRECAUTIONS
4. If something goes wrong, immediately stop operation and find the cause. Do not use again until you have solved the
problem.
HOW TO CONNECT
CAUTION
- Use clean air filtered through air dryer and air filter. If not, dirty air can cause painting failure.
- When you use this gun for the first time after purchasing, adjust fluid needle packing set.
Slowly tighten fluid packing seat and loosen a bit when fluid needle set does not return
smoothly, and adjust so that fluid needle set smoothly moves.
- When use this gun for the first time after purchasing, clean fluid passages spraying thinner
and remove rust preventive oil.
If not, remaining preventive oil can cause painting failure such as fish eyes.
- Firmly fix hose or container to spray gun. If not, disconnection of hose and drop of container can
Ref. Part
cause bodily injury.
1
2
4
1. Connect an air hose to air nipple tightly.
5
2. Connect an applicable cup to fluid nipple tightly.
7
3. Flush the gun fluid passage with a compatible solvent.
7-1
7-2
4. Pour paint into container, test spray and adjust fluid output as well as pattern width.
7-3
7-4
7-5
HOW TO OPERATE
10
11
Suggested air pressure is 2.0 to 3.0 bar (29 to 44 PSI)
13
14
15
Recommended paint viscosity differs according to paint property
17
and painting conditions. 12 to 23 sec. / Ford cup #4 is recommendable.
18
19
C
Keep fluid output as small as possible to the extent that the job will
D
not be hindered. It will lead to better finishing with fine atomization.
25
20
Set the spray distance from the gun to the work piece as near as
20-1+B
E
possible within the range of 100_200 mm (3.9_7.9 in).
26
The gun should be held so that it is perpendicular to the surface of the workpiece at all times. Then, the gun should move in a straight
27
and horizontal line. Arcing the gun causes uneven painting.
28
29
30
31
100.200 mm
3.9-7.9 in
3