Astrolite HELIOS 3W Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Astrolite HELIOS 3W. Astrolite HELIOS 3W 5 pagina's.

INTRODUCTION

Thank you for having chosen the item. You will see you have acquired a powerful

and versatile device. Unpack your item. Before you initial start-up, please make sure that there

is no damage caused by transportation. Should there be any, consult your dealer and do not

use the device.

SAFETY INSTRUCTIONS

Be careful with your operations. With a dangerous voltage you can suffer a dangerous

electric shock when touching the wires!

Keep this device away from rain and moisture!

Unplug mains lead before opening the housing!

For your own safety, please read this user manual carefully before you initial start-up.

If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do

not switch it on immediately. The arising condensation water might damage your device.

Leave the device switched off until it has reached room temperature. Never let the power-cord

come into contact with other cables! Handle the power-cord and all connections with the mains

with particular caution! Make sure that the available voltage is not higher than stated on the

rear panel. During the operation, the housing becomes very hot. Do not switch the device on

and off in short intervals as this would reduce the lamp's life.

Never look directly into the light

source, as sensitive persons may suffer an epileptic shock (especially meant for epileptics)!

Keep away from children and amateurs! This product is designed for both indoor and outdoor

use with IP65 ingree protection. This device is designed for professional use, e.g. on stages, in

discotheques, theatres etc. The minimum distance between light-output and the illuminated

surface must be more than 0.5 meters. Always fix the fixture with an appropriate safety-rope.

The maximum ambient temperature t

= 45° C must never be exceeded. Operate the device

only after having become familiar with its functions.

Features

Four operation modes: DMX 512 protocol, auto and master/slave and sound active operating

in various modes to form different led effects

On the rear panel of the item you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In),

which can be used for connecting several devices. Choose the device which is to control the

effects. Connect the DMX OUT-jack with the DMX IN-plug of the next device.

The wires must not come into contact with each other, otherwise

Occupation of the XLR-connection:

If you are using controllers with this occupation, you can connect the DMX-output of the

controller directly with the DMX-input of the first fixture in the DMX-chain. If you wish to

connect DMX-controllers with other XLR-outputs, you need to use adapter-cables.