Air Hogs Hyper Actives Gebruiksaanwijzing - Pagina 2
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Air Hogs Hyper Actives. Air Hogs Hyper Actives 2 pagina's. 2.4ghz performance vehicle 12+ years expert
Pagina afdrukken
VEHICLE TRIM ADJUSTMENT
If the vehicle is not driving
straight when you have the
directional control wheel in the
forward position, use the trim
dial to correct the problem.
1. If the vehicle turns to the
right, slowly turn the trim dial
to the left until the vehicle
drives straight.
2. If the vehicle turns to the left,
slowly turn the trim knob to
the right until the vehicle
drives straight.
Before using your
Hyper Actives™
outdoors, carefully
remove the rubber
foam indoor tires and
replace them with
the rubber all terrain
outdoor tires!
SELF-RIGHTING ROLLBAR
A fast, quick turn will cause
the vehicle to roll over and the
self-righting roll bar will return
the vehicle onto its wheels!
PROBLEM
Vehicle is slow or will not move.
Vehicle does not drive in a
straight line.
My vehicle and/or remote is dirty.
Vehicle is not responding or driving
on it's own.
NOTE: If normal function of the product is disturbed or interrupted, strong
electro-magnetic interference may be causing the issue. To reset product, turn it
completely off, then turn it back on. If normal operation does not resume, move the
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received,
This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must
including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are
accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for Class B digital
designed to provide reasonable protection against harmful interference to radio communications. Because this toy generates, uses, and can radiate radio frequency energy, there can be no guarantee that
devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment generates,
interference will not occur. if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this toy does cause interference to radio or television reception
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. If this toy does cause
(you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful: • Reorient or relocate the receiving antenna • Increase the separation
interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful:
between the toy and the radio or the TV • Consult the dealer or an experienced TV-radio technician for help. NOTE:Changes, adjustments or modifications to this unit, including but not limited to, replacement of any
• Reorient or relocate the receiving antenna • Increase the separation between the toy and the radio or the TV • Consult the dealer or an experienced TV-radio technician for help.
transmitter component (crystal, semiconductor, etc.) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd. or they could void the user's authority to
NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc) could result in a violation of
operate the equipment.
FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd. or they could void the user's authority to operate the equipment.
CANADIAN Class B statement: This Class B digital apparatus meets all of the requirements of the Canadian Interference-Causing Equipment Regulations.
Your Hyper Actives™ is equipped with a Lithium Polymer battery.
SPECIAL LIPO BATTERY INSTRUCTIONS:
- Never charge battery unattended.
- Charge battery in isolated area. Keep away from flammable materials.
- Do not expose to direct sunlight.
- There is a risk of the batteries exploding, overheating, or igniting. Do not disassemble, modify heat,
or short-circuit the batteries. Do not place them in fires or leave them in hot places.
- Do not drop or subject to strong impacts.
- Do not allow the batteries to get wet.
- Only charge the batteries with the specified Spin Master™ battery charger.
- Only use the batteries in the device specified by Spin Master™.
- Carefully read the instruction guide, and use the batteries correctly.
- In the unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery.
- Batteries must be recycled or disposed of properly.
Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100,
Williamsville, NY 14221, USA
Spin Master Toys Far East Limited, Rm #1113, 11/F, Chinachem Golden Plaza,
77 Mody Rd., Tsimshatsui E., Kowloon, HK
North American Consumer Information
Phone: 1-800-622-8339
Email: [email protected]
www.spinmaster.com
1
2
CHANGING TIRES
TROUBLESHOOTING GUIDE
CAUSE
1. Batteries in the controller need to be
replaced if green power light is flashing.
2. Vehicle is out of range of controller.
3. There is hair or debris stuck in the wheels
or wheel axles.
4. Batteries are installed incorrectly.
5. Improper surface for vehicle.
6. Remote not aimed at vehicle or objects
interfering with signal.
7. Remote was inactive for 30 seconds
or more and turned itself off to preserve
your batteries.
Vehicle requires wheel alignment.
1. Inappropriate driving surface.
2. Dirty hands.
1. Using another vehicle remote/
charger of the same frequency.
2. Infrared interference from another source.
Air Hogs
®
, related trademarks & © 2011 Spin Master Ltd. All rights reserved.
This product conforms to safety requirements of ASTM F-963 & CHPA. • Please retain
this information for future reference. • Please remove all packaging materials before
giving to children. • An adult should periodically check this toy to ensure no damage
or hazards exist, if so, remove from use. • Children should be supervised during play.
• Keep addresses and phone numbers for future reference. • The item inside this
package may vary from the photographs and/or illustrations. MADE IN CHINA.
20043334, 20043335, 20049415, 20049426
T20418_0001_20043334_NEN_IS_R1
VARIABLE SPEED DIAL
Moving the variable
speed dial to
the right will limit
the throttle travel
decreasing the
amount of speed
available. Moving
the dial to the left will
activate full throttle
and maximum
speed.
WHEN FINISHED PLAYING
Turn vehicle OFF.
Turn remote/charger OFF.
1. Replace batteries in the remote with new, fresh batteries.
2. Move closer to the vehicle.
3. With the vehicle and remote turned off, have an adult carefully remove the hair
or debris from the wheels or wheel axles. Remove debris by blowing gently on
the wheel assembly area located on the bottom of the vehicle.
4. With the vehicle and remote turned off, have an adult check that the batteries
are installed correctly in the remote.
5. Examples of poor play surfaces are thick grass, sand or pebbly areas. Examples
of good play surfaces are tiles, concrete or asphalt.
6. Point remote IR at the vehicle. Ensure there are no objects blocking the
controller "line of sight" to the vehicle.
7. Press the ON/OFF button.
Refer to Trim Adjustment guide above.
Ensure the remote and vehicle are off. Have an adult remove the batteries first
and replace the battery cover. Slightly dampen a clean cloth in water and wipe toy
clean. DO NOT IMMERSE IN WATER and DO NOT USE ANY CHEMICALS.
Let the toy completely dry before putting batteries back into clean, dry battery
compartment.
1. Only use the remote/charger supplied with this vehicle.
2. Do not operate vehicle around devices that emit other infrared signals.
product to another location and try again. To ensure normal performance, change
the batteries, as low batteries may not allow full function.
PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed,
product disassembly and battery removal must be performed by an adult. Do not puncture,
cut, tear, compress or deform product during disassembly. Ensure product is turned off,
then use a screw driver to remove all screws. Separate product body halves to expose
internal electronics. When battery is visible in its entirety use scissors to cut a single battery
wire, immediately wrap the cut wire end with tape to isolate it, repeat until all battery wires
are cut and isolated, and the battery is free from the rest of the product. Dispose of battery
in accordance with your local battery recycling or disposal laws. NOTE: Opening of
product and/or removal of battery will render product inoperative and voids manufacturer
warranties, dispose of remaining product components in accordance with local laws.
REV 0
SLOW
FAST
O
CHG OFF ON
SOLUTION
I
TM