Dorex DX2 FC Handleiding voor installatie-instructies - Pagina 7

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Dorex DX2 FC. Dorex DX2 FC 12 pagina's.

Pagina afdrukken
07. INSTALL CONNECTORS
Rod Screws
Connector
Bottom Rod
After adjusting the rod lengths, Install connectors on both
concealed rods with rod screws.
Notch
of
Connector
Bottom
Rod
NOTE: Position connector on top rod with its notch facing
towards top of door; repeat this step with connector at
bottom rod with its notch facing towards bottom of the door.
(*) Doors with cladding on the exit device side will require
spacers between the the rod and the connector.
08. INSTALL TRIM (IF USING) AND SECURE DEVICE
CENTER CASE TO DOOR. (CONTINUED)
Support Bracket
Center case aligned
with mounting holes.
NOTE: 1. Install center case with both connectors
go through clearance between retractors
and center case.
2. Install support bracket on the top of
connector and retractor.
L
Top Rod
Connectors for
L C
of Device
1-3/4" door
thickness*
Top
Rod
08. INSTALL TRIM (IF USING) AND SECURE DEVICE
CENTER CASE TO DOOR
1 ³/16" Minimum clearance
(with end cap removed).
If device is too long for door,
see "CUT DEVICE"
on page 12.
1. DEVICE WITH TRIM - See "Trim Instructions".
2. EXIT ONLY - Mount center case to the door with four(4)
center case screws.
09. INSTALL MOUNTING BRACKET AND END CAP
Device must
be horizontally
leveled.
End Cap
Bracket
1. Remove cover plate, insert end cap bracket into push bar
assembly against mechanism case. Level device, mark
and drill two(2) holes for Bracket Screws (see p.4). Fasten
end cap bracket screws to door.
Cover Plate
End
Cap
Screws
J
2. Insert cover plate, slide anti-rattle clip in position
(2" minimum from end), and attach end cap with two(2)
end cap screws.
7 / 12
Door Stop
(On Frame)
Center Case
Screws
E F
Latch Release
Plunger Hole
(See p.6)
Trim
(Optional)
End Cap Bracket Screws
Refer to SCREW CHART on page 3
C
Anti-Rattle Clip
2" Minimum
End Cap