Dorex DX2 FW Handleiding voor installatie-instructies - Pagina 5

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Dorex DX2 FW. Dorex DX2 FW 16 pagina's.

Pagina afdrukken

01. DRAW HORIZONTAL EXIT DEVICE

AND STRIKE CENTERLINES

C L

Hinge

⁵⁄8"

Side

to Finished

Floor or

Threshold*

Close door, mark horizontal centerline on inner side of door

and on door stop. The distance of centerline measured from

finished floor should be 39

centerline should be measured on outer side of door as well.

03. INSTALL STRIKE AND SHIMS

Strike Shim

DXAS103

Strike Screws

C L

Prepare two(2) holes and install a screw

through each slot.

RHR shown

(LHR opposite)

Door Stop

(hollow metal frame)

* A ¹⁄4" gap is required

between the bottom of

the door and the finished

floor or threshold.

. If trim is used, horizontal

⁵⁄8"

L C

Aluminum

frame with ¹⁄2"

blade stop

02. POSITION CENTRE CHASSIS STRIKE AND

MARK HOLES

DX2PW (PANIC EXIT)

DEFAULT STRIKE: DXAS103

DX2FW (FIRE EXIT)

DEFAULT STRIKE: DXAS108 (See page 12)

For DX2PW (PANIC EXIT) with hollow metal

frames with 5/8" door stop use optional

DXAS106 strike (See page 11)

Cut stop to

clearance for

L C

Use strike as template and place it against inner side of

door and door stop such that strike is aligned both with

centerlines on door and on stop.

Mark top & bottom of strike and cut stop, then mark

centers then drill/tap holes as required. See Step 3.

04. POSITION TEMPLATE AND MARK HOLES FOR

MAIN CHASSIS

Mark door

cut-out

L C

Use template DX2PR/FR

Position and tape exit device template (and trim template

if trim is used), making sure the centerlines of the

template and door are aligned as shown in above figure.

Mark centers and drill / tap the required holes as indicat-

ed on the template.

5 / 16

METAL

#25 DRILL

#10-24 TAP

WOOD

¹⁄8" DRILL

PILOT 1" DEEP

DXAS103

provide

2 ⁷⁄8"

Strike for

(73 mm)

Panic Exit

strike

L C

Device

Aluminum

frame with ¹⁄2"

blade stop

Align template on vertical and

horizontal centerlines and in-line

with the roller strike

L C

Mark four(4)

Holes