Dorex DX2 PV Handleiding voor installatie-instructies - Pagina 7
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Dorex DX2 PV. Dorex DX2 PV 12 pagina's.
Pagina afdrukken07. INSTALL MOUNTING BRACKET AND END CAP
Level Device
End Cap
End Cap Bracket
Bracket Screws
1. Remove cover plate, insert end cap bracket into the push
bar rail assembly as shown.
2. Level exit device, then mark both mounting hole centers.
Drill and tap, then fasten bracket with the appropriate
mounting screws.
End Cap
Screws
J
End Cap
3. Insert cover plate, then slide anti-rattle clip into
position (minimum 2" from end) before fixing end
cap with supplied screws.
08. INSTALL TOP LATCH AND ROD (CONTINUED)
Rod
Rod
Connecting
Bar
Connecting
F
Screw
3. Attach the connecting Bar to the bottom of the top
rod with supplied screw (Figure 3)
C
2" Minimum
Cover Plate
Anti-Rattle Clip
Connecting
Screws
Connecting
Bar
Notch
Tab
NOTE:
Match notch of the connect-
ing link with tab of rod before
tighten connecting screw
Figure 3
08. INSTALL TOP LATCH AND ROD
Top Latch
Sex Bolts
F
Latch
Screws
Figure 1
1. Align top latch with top strike then install
top latch with two mounting screws (and
through-bolts for Fire). Adjust strike for
proper engagement. (Figure 1.)
2. Supplied rods are for 7 ft (84") door
height. if door height is less than 7 ft,
shorten the top rod by the difference
(Figure 2). Refer to page 10.
Rod
Guide
Top
Latch
4. Assemble rod guide with rod, thread rod into top latch until first
hole in connecting bar align with first hole in retractor and
fasten with side screws.
7 / 12
Amount
H
to
Cut Off
Actual
Door
Opening
Height
Connecting
Bar
Second
Holes
First Holes
Figure 2
Side
Screws