Bolink R/C LEGENDS Montagehandleiding - Pagina 3

Blader online of download pdf Montagehandleiding voor {categorie_naam} Bolink R/C LEGENDS. Bolink R/C LEGENDS 6 pagina's. Chassis kit

STEP 7 SLIDE ONE OF THE THIN AXLE WASHERS ON THE

PREASSEMBLED DIFFERENTIAL, THEN SLIDE IT THRU THE

BUSHINGS AS SHOWN. LUBE EACH BUSHING WITH A DROP

OF LIGHT OIL. SLIDE ANOTHER THIN WASHER ON, THEN ADD

THE 1/2" WIDE SPACER, FOLLOWED BY THE NYLON HUB.

INSTALL TWO SETSCREWS IN THE HUB CAREFULLY. MAKE

SURE YOU HAVE A SMALL AMOUNT OF SIDEPLAY IN THE

AXLE. TIGHTEN EACH SETSCREW A LITTLE AT A TIME TO

KEEP FROM WARPING THE HUB.

STEP 9 INSTALL YOUR SERVO UNDER THE BATTERY TRAY

AS SHOWN WITH A PORTION OF THE SERVO TAPE

PROVIDED IN BAG 6L. MOUNT THE SERVO AS FAR TO ONE

SIDE AS YOU CAN TO GET THE SERVO OUTPUT SHAFT AS

CLOSE TO THE CENTER AS POSSIBLE. USE A LARGE TIE

STRAP TO HELP HOLD THE SERVO IN PLACE. OPEN BAG 3L2

AND INSTALL A SHORT AND LONG STEERING LINK ON EACH

SIDE BETWEEN THE SERVO AND STEERING BLOCK. SLIDE A

COLLAR WITH SETSCREW OVER EACH PAIR THEN ALIGN

THE STEERING AND TIGHTEN EACH SET SCREW.

STEP 6 OPEN BAGS 2L AND 2L1 AND INSTALL A BUSHING

STEP 6

ADAPTOR INTO EACH CHASSIS SIDE PLATE. BOTH

ADAPTERS MUST BE INSTALLED IN THE SAME WAY WITH

EITHER THE HOLE UP OR DOWN AS SHOWN. FOLLOW THIS

BY PRESSING A REAR AXLE BUSHING INTO EACH ADAPTER.

STEP 8 OPEN BAG 3L1 AND INSTALL THE MOTOR YOU

STEP 8

HAVE CHOSEN INTO THE CHASSIS WITH THE SOCKET HEAD

MOTOR SCREWS AND WASHERS. INSTALL THE PINION GEAR

WITH THE SETSCREW AND ALIGN IT WITH THE AXLE SPUR

GEAR THEN TIGHTEN. SLIDE THE MOTOR BACK UNTIL YOU

HAVE A VERY SMALL AMOUNT OF PLAY IN BETWEEN THE

GEARS. TURN THE GEAR A COUPLE OF TIMES TO RECHECK

THE MESH, THEN TIGHTEN THE MOTOR SCREWS SECURELY.

STEP 7

STEP 9