Cansec VIA Installatiehandleiding - Pagina 16

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Cansec VIA. Cansec VIA 20 pagina's. Universal wireless lock
Ook voor Cansec VIA: Installatiehandleiding (10 pagina's)

Pagina afdrukken

DIP SWITCH "E" - PROGRAM MODE

This is the large RED switch and is used to put the board into PROGRAM or RUN mode. When-

ever ANY of the programming DIP switches are changed, the PROGRAM DIP switch must be set

to PROGRAM (UP/ON) and the reset pushbutton to its immediate right must be momentarily

pressed. This loads the defined program values into memory and verifies them. When the PRO-

GRAM function is completed, the Via control unit will beep and will continue to beep until the

DIP switch is returned to the RUN position (DOWN/OFF) and the reset switch is pressed again.

The Via Lock will then attempt to connect to it's assigned Via Hub. You can verify that it is con-

nected by operating the inside lever. If the event is detected and successfully transmitted to the

Hub, the blue Connection Status LED in the top left corner of the controller board will blink once.

POWER ON CONTROL UNIT

1. Connect the following cables to the Control Unit (see Figure 4 for location).

• LED Cable and Reader Cable from the Via Reader

• Lock Motor Cable and the REX Cable from the Lockset

• Door Contact Cable from the Door Contact (optional)

2. Snap 4 AA batteries in the battery holder to power up the Control Unit (see Figure 4).

3. Press the Reset button.

READER STATUS LEDS

The Via Lock reader is equipped with three status LEDs. These LEDs make it very simple to com-

mission the systems and monitor its ongoing operation. When a card is presented:

• The RED LED will flash ONCE to confirm that the card was read.

• The GREEN LED will flash ONCE to confirm that the Wiegand

data has been sent to the Via Hub.

• The YELLOW LED may flash ONCE to indicate that the transac-

tion was successfully received by the Hub but the signal level is weak.

This could be caused by the introduction of a physical obstruction

which was not present the the Via Lock was initially installed.

• The YELLOW LED may flash TWICE if the battery level is low.

• The YELLOW LED may flash THREE times if the signal level is

weak AND the battery level is low.

• If access is granted, the Lock will beep ONCE and the GREEN LED

will come on momentarily.

• If access is denied, the RED LED will flash TWICE.

• If the battery level is so low that the card data cannot be sent to the

Hub, the RED and YELLOW LEDs will come on momentarily when

a card is presented.

Via Wireless Lock

Installation Manual

READER STATUS LEDS

(RED, YELLOW, GREEN)

Figure 6:

Reader Status LEDs

Page

July 2018 • Rev. 1.3