Bolton Tools HP-L4G Installatie-, bedienings- en onderhoudshandleiding - Pagina 4
Blader online of download pdf Installatie-, bedienings- en onderhoudshandleiding voor {categorie_naam} Bolton Tools HP-L4G. Bolton Tools HP-L4G 16 pagina's. Two-post model autolift
*
Lift capacity ratings are based on loads equally distributed on all four arms.
** Lifting and lowering speeds may vary depending on weight of vehicle.
V
ERTICAL CLEARANCE
Check the height of the area where the lift is to be installed. Clearance should be calculated based on the
full raised height of the lift.
Be certain you have the proper concrete floor to properly handle the loaded lift. Floor should be in
generally good condition with no large cracks, spalling or deterioration.
Minimum requirements for concrete are 4 inches minimum depth, with steel reinforcement, 3500
PSI, cured for 28 days per local commercial practice.
Floor should be level within 3/8 inch over the installation area. No anchors should be installed within 8
inches of any crack, edge, or expansion joint. If these conditions cannot be met, pads can be poured to
accommodate the lift.
Check with local building inspectors and/or permits office for any special instructions or approvals
required for your installation.
E
LECTRICAL REQUIREMENTS
For lift installation and operation for single phase units, it is necessary to have a dedicated circuit with a
double pole 25 amp circuit breaker or time delay fuse.
S
AFETY NOTICES AND DECALS
For your safety, and the safety of others, read and understand all of the safety notices and decals included
here.
READ ENTIRE MANUAL BEFORE ASSEMBLING, INSTALLING, OPERATING, OR
SERVICING THIS EQUIPMENT.
PROPER MAINTENANCE AND INSPECTION IS NECESSARY FOR SAFE OPERATION.
DO NOT OPERATE A DAMAGED LIFT.
Failure by purchaser to provide adequate clearance could result in
unsatisfactory lift performance, property damage, or personal injury.
F
LOORING
Failure by purchaser to provide the recommended mounting
surface could result in unsatisfactory lift performance, property
damage, or personal injury.
2