Akzu Sprite X3 Series Installatie-instructie

Blader online of download pdf Installatie-instructie voor {categorie_naam} Akzu Sprite X3 Series. Akzu Sprite X3 Series 5 pagina's. Surface mounting

Pagina afdrukken

Warning and safety instructions

1. Only interior using for this type of luminaire.

2. Main voltage supply must be disconnected or switched off before installation, uninstall or cleaning.

3. Use the enclosed protective gloves when handling the reflector, if applicable.

4. Ensure there is enough space for heat dissipation of the luminaire, do not place anything in 10cm around the luminaire. The luminaire must not

under any circumstance be covered with heat insulating materials.

5. The luminaire must not be installed on inflammable parts of building.

6. Keep object out of the required minimum distance along the optical axis of the light source.

7. Please refer to the specific installation instructions, the label or imprint on the luminaire for information concerning any restrictions relating to

the use of luminaire, type of installation and etc.

8. If necessary the ceiling should be reinforced at the supporting points of the mounting frame or bracket.

9. The luminaire must only be operated with control gear matching the LED module provided or recommended by AKZU. No liability is accepted if

used with other control gears.

10. When installing, always observe relative local rules and regulations.

Limitations

Our warranty is contingent upon the observance of this product information, in particular, it shall be void if the fitting instructions are not followed,

the fitting dimensions are not observed, or any modification is made to the luminaire.

Cleaning

1. Luminaires should be cleaned regularly to make sure its working in good condition.

2. Disconnect the power and wait it is cooled down before cleaning.

3. Use soft cloths to clean.

4. Use litmusless detergent.

5. Do not use rigid, sharp, frictional or similar material or tool to clean

6. Do not use acidic, alkaline, ethanol or similar chemicals to clean.

All data, images,

and specifications

are for reference only and

may be changed due to

product improvement

without prior notice.