DAEWOO ELECTRONICS FRA-X22D Gebruikershandleiding - Pagina 16

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DAEWOO ELECTRONICS FRA-X22D. DAEWOO ELECTRONICS FRA-X22D 18 pagina's.

Pagina afdrukken

How to install Water Line

(Dispenser models only)

1. The water pressure should be 2.0~12.5 kgf/cm²

(1.96 ~12.26 Bar) or more to run the automatic icemaker.

Check your tap water pressure; if a cup of 180cc is

full within 10 seconds, the pressure is OK.

2. When installing the water tubes, ensure they are not

close to any hot surfaces.

3. The water filter only filters water; it does not eliminate

any bacteria or microbes.

4. If the water pressure is not sufficient to run the icemaker,

call the local plumber to get an additional water pressure

pump.

5. The filter life depends on the amount of use. We

recommend you to replace the filter at least once every

6 months.

6. After installation of refrigerator and water line system,

select [WATER] on your control panel and press it for

2~3 minutes to supply water into the water tank and

dispense water.

7. Use plumbers thread sealing tape on every connection of

pipes/tubes to ensure there is no water leaks.

8. The water tube should be connected to the cold water

line.

WATER SUPPLY KIT

Check the parts below for installing water supply.

Some other necessary parts are available at your local

service agents.

Installation Procedure

(Dispenser models only)

1. Join connector to the tap water line

Figure A

Figure B

Place the rubber washer inside the tap connector

and screw onto the water tap.

2. Connect the Water Tube to the refrigerator.

1) Remove the rear cover at the bottom back of the

refrigerator.

2) Insert the fastening ring into the Water tube. (Be careful

to follow the direction of the nut.)

3) Insert the Water Tube into the top of the Water Valve,

turn the nut clockwise to fasten it. (The Water valve is to

the right of the motors.)

4) Check for any bent tubes or water leaks; if so, reckeck

installation procedure.

5) Replace the rear cover. (The Water Tube should be

placed between the groove of the refrigerator back and

motor cover.)

Set the tube upright as the figure shows.

3. After installation of Water Supply System

1) Plug in the refrigerator, press the [WATER] button on the

control panel for 2~3 minutes to remove any air (bubble)

in the pipes and drain out the initial water.

2) Check for the water leaks again through the water supply

system(tubes, connectors and pipes). Rearrange the

tubes again and do not move the refrigerator.