Dot-Spot LED recessed spot basic mini Gebruikershandleiding - Pagina 10
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dot-Spot LED recessed spot basic mini. Dot-Spot LED recessed spot basic mini 12 pagina's.
Pagina afdrukken
Safety instructions
In order to protect the exposed connection cable when there is a risk of animal damage, it should
be equipped with a Marten protection (mounting accessories) are provided. Luminaires / power
supplies with defective cables must not be operated any further.
High ambient temperatures shorten the service life of the LEDs. To get a long lifetime of the LED,
good heat dissipation must be ensured. Therefore, do not expose the LED spotlight to ambient tem-
peratures> 50 ° C during operation. Do not cover the LED spotlight, ensure that air can circulate
freely.
Assembly
Direct installation of the spot into the substrate
The installation of the recessed spotlights can be directly installed in all suitable materials that have
the necessary strength to hold the recessed spotlight, e.g. wood, concrete and natural stone. The
radiator is clamped in the mounting hole by the stainless steel springs on the side and is held in this
way. Note the position of the luminaire and the resulting stress of the material.
Drill the mounting hole for the light. The required drill hole diameter is 42 - 45 mm. If the luminaire
is to be used in a solid material, e.g. solid concrete wall, stone, screed floor, the mounting hole must
be 60 mm deep, plus space for the respective cabling. A deeper hole makes it easier to accommo-
date the excess supply cable when inserting the light.
If the luminaire is loaded, the surface on which the cover of the luminaire rests must be level and
able to absorb the load.
Plug the connection cable of the spot into the corresponding socket of the power supply unit. If
further extension sets are connected, use the corresponding cable distributor and, if necessary, the
extension cable available as a special accessory. Make sure that the union nuts of the connectors
are firmly tightened, this is the only way to guarantee protection against moisture. The connector
system is reverse polarity protected. We recommend burying the connection cables to protect them
from being bitten by animals or laying them in a conduit. The power supply unit should be placed
in a location that is as protected from the weather as possible. Avoid constant moisture and direct
sunlight. Make sure that the power supply unit cannot be flooded, even in heavy rain. The power
supply unit must not be buried. If necessary, use a housing to protect the power supply unit from
the elements.
Maintenance, care
Clean the LED spotlight from time to time with a damp cloth. Do not cover the spots, remove any
leaves covering the LED spot and ensure that heat can dissipate freely from the housing.
The dot-spot recessed spots are built without potting, so they can be dismantled and repaired.
This is also an important contribution to environmental protection. Even after the warranty period
has expired, the LED spotlight can be repaired in the event of a fault or damage dot-spot offers
attractive flat-rate repair fees.
10