Advance Tabco FC-WM-60EFADA Installatie-instructies - Pagina 2

Blader online of download pdf Installatie-instructies voor {categorie_naam} Advance Tabco FC-WM-60EFADA. Advance Tabco FC-WM-60EFADA 2 pagina's. Wall mounted sinks

Pagina afdrukken
CARTON CONTENTS:
(1) Sink
(2) "Z" Wall Brackets
Tubular Wall
Supports*
Faucet(s)*
Drain(s)*
*See Below For Proper Quantities Supplied Per # Of Stations:
MANUAL OPERATED SERIES
# of
# of Drains
# of Faucets
# of Supports
Stations
Included
Included
1
1
Not Included
2 Support Brackets
2
1
Not Included
2 Support Brackets
3
1
Not Included
2 Support Brackets
4
1
Not Included
2 Support Brackets
5
2
Not Included
4 Support Brackets
6
2
Not Included
4 Support Brackets
ELECTRONIC FAUCET OPERATED SERIES (EF Series)
# of
# of Drains
# of Faucets
# of Supports
Stations
Included
Included
1
1
1
2 Support Brackets
2
1
2
2 Support Brackets
3
1
3
2 Support Brackets
4
1
4
2 Support Brackets
5
2
5
4 Support Brackets
6
2
6
4 Support Brackets
KNEE OPERATED SERIES (KV Series)
# of
# of
# of
# of
Drains
Faucets
Knee Valves
Stations
Included
Included
Included
1
1
1
1
2
1
2
2
3
1
3
3
4
1
4
4
5
2
5
5
6
2
6
6
TOOLS NEEDED (Not Included):
5/32" Allen Wrench
7/16" Open End Wrench
STEP 1
Carefully remove contents of carton/crate. Position sink
upside down on a protected surface so you can access the
underside of the sink. Install tubular wall supports into Sink
gussets (Figure 1).
Included
Figure 1
STEP 2
Lightly tighten each Set Screw using 5/32" Allen
Wrench. Do not over-tighten at this time (Figure 2).
Included
# of Supports
Included
2 Support Brackets
2 Support Brackets
2 Support Brackets
2 Support Brackets
4 Support Brackets
4 Support Brackets
PLEASE NOTE: Some models may require Set
Screws to be inserted into the Set Screw Holes.
STEP 3
Place Sink upright and install drain(s)
and faucet(s) at this time. Your plumbing
contractor is responsible for local code
requirements.
Sink
Bottom
STEP 4
Mount the provided wall "Z" brackets to wood studs or
cement walls for strong support. Mount the brackets at
recommended height of 42" from the finished floor to the
to the top of the bracket (Figure 3).
A.D.A. sink models, be sure to review A.D.A. codes
Figure 2
for proper install
dimensions on next page.
Slide the sink onto the wall brackets and be sure the sink
sits securely on them.
Figure 3
Actual "Z"
Bracket Shown
K-6 Basket
Drain shown
1/4" continuous
bead of Plumber's
Putty or Silicone
Sealer.
Rubber Washer
Paper Washer
Die Cast Nut
When installing
heights. See suggested rough-in
Silicone Sealer
"Z"
Bracket
Back Splash