dough Xpress DXM-SSCP Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} dough Xpress DXM-SSCP. dough Xpress DXM-SSCP 2 pagina's. Manual meat press

Pagina afdrukken

RECEIVING & INSTALLATION

Please read this manual in its entirety before operating your press.

UNPACKING

Remember to save all packing materials - including any crating, boxes,

liners and boards. You may need these for shipping your machine or should

a repair be necessary in the future.

INSPECTION

Inspect your machine for hidden shipping damage. Contact the delivery

company immediately, should you ﬁ nd damage.

PLATEN SURFACE

Slight surface imperfections are a normal part of the aluminum casting

process for the platens on your press. These are not considered a defect

and do not affect the functionality of the machine in any way.

OPERATION

Thickness Control Knob

INSTALLATION

Remove from box (Keep box just in case you need to return). Team lift

machine is very heavy.

1. With the press in the open position, adjust the press

to the desired thickness by turning the thickness

control knob located on the top of the machine.

Thickness is reduced by turning knob clockwise

and increased by turning it counterclockwise as

indicated. Using the thickness control knob, turn

right for thicker or left for thinner until you have the

thickness you desire.

CAUTION: DO NOT OPERATE THIS PRESS WITH ANY OTHER

PERSON(S) / HAND(S) NEAR YOU OR THE PRESS.

SERIOUS INJURY COULD RESULT.

2. Pull down the handle all the way, applying pressure, until it stops. Raise

the handle all the way up.

Rotate the lower platen out and remove your ﬂ attened product.

CLEANING & MAINTENANCE

WARNING: Before cleaning, performing maintenance or repairs make sure

the machine is turned off and the machine is unplugged.

***This appliance is not waterproof. Never spray or pour water or

any other cleaning solution onto this appliance.***

CLEANING PTFE COATED PLATENS

1. Unplug the machine and allow it to cool.

2. Open the heat platen for easier access.

3. Clean the PTFE coated platen with a mild soap and warm water

applied with a soft cloth or sponge. Do not use steel wool, scrub

sponges, kitchen or oven cleaners or any other kind of abrasive ma-

terial. This will damage the coating.

4. Wipe clean with a dry cloth.

CLEANING OUTSIDE SURFACES OF THE MACHINE

Use a mild soap and warm water applied with a soft cloth or sponge.

Do not use steel wool, scrub sponges, kitchen or oven cleaners or other

abrasives that will damage the painted surface.

LUBRICATION

Your press requires lubrication every 15,000 cycles or every 6 months.

Use NSF/NLGI2 rated food grade grease (such as Bel-Ray No-Tox #2 or

equivalent). Lubricate all moving or hinged points.