Baumer OM30 Bedieningshandleiding - Pagina 7

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Baumer OM30. Baumer OM30 48 pagina's. Laser distance sensors

Baumer

Safety

2.1

Certain work with the product may only be carried out by specialized personnel.

Specialized personnel are staff members who can evaluate the tasks assigned to them and rec-

ognize potential danger, based on their training and work as well as a reliable understanding of

technical safety issues.

Qualified personnel are divided into the following categories:

Instructed personnel:

A person who has been informed and, if required, trained, by a specialist about the assigned

tasks and potential dangers of improper behavior.

Specialist:

A person who, based on his/her training, experience, and instruction, as well as his/her

knowledge of applicable standards, rules, and accident prevention regulations, has been au-

thorized to carry out the respectively required tasks, while recognizing and avoiding poten-

tial dangers.

Electrical specialist:

A person with the appropriate specialist training, knowledge, and experience allowing him/

her to recognize and avoid dangers originating from electricity.

2.2

Intended use

This product is a precision device and serves the detection of items, objects, or physical mea-

surement variables and the preparation or provision of measured values as electric variables for

the higher-level system.

Unless specifically labeled, this product may not be used in explosive environments.

Commissioning

Assembly, installation, and calibration of this product may only be performed by a specialist.

Installation

Only use the fasteners and fastener accessories intended for this product for installation. Out-

puts not in use must not be wired. Unused wires of cable outputs must be insulated. Do not go

below the permissible cable bending radii. Disconnect the system from power before the prod-

uct is electrically connected. If required, shielded cables must be used to prevent electro-mag-

netic interference. If the customer assembles plug connections on shielded cables, then EMC-

version plug connections should be used and the cable shield must be connected to the plug

housing across a large surface area.

Disposal (environmental protection)

OM20/OM30 | V1

Used electrical and electronic devices may not be disposed of in household

waste. The product contains valuable raw materials that can be recycled. There-

fore, dispose of this product at the appropriate collection point. For additional in-

formation, visit www.baumer.com.

Operating Manual

Safety