Douglas Dynamics WESTERN MVP PLUS 44575-1 Handleiding voor installatie-instructies - Pagina 6

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Douglas Dynamics WESTERN MVP PLUS 44575-1. Douglas Dynamics WESTERN MVP PLUS 44575-1 15 pagina's. Snowplow

Pagina afdrukken
Pivot Bar to Pivot Plates
1. Position the T‑frame and pivot bar between the
pivot plates, aligning the hole at each end of the
pivot bar with the appropriate hole in the pivot
plate as determined by distance "d."
2. On each side, insert 1" x 4‑3/4" clevis pins from
the inside of the pivot bar through the correct pivot
plate holes. Secure the clevis pins with 1" flat
washers and 1/4" x 1‑1/2" cotter pins.
1" Flat
Washer
1/4 x 1-1/2"
Cotter Pin
Pivot Bar
1" x 4-3/4"
Clevis Pin
Lit. No. 43174, Rev. 04
INSTALLATION INSTRUCTIONS
Pivot Plates
STAND SHOE
The stand plunger spring is shipped
compressed and tied. Do not cut the spring
tie until final stand shoe adjustment is
complete and the roll pin is installed.
Initial stand shoe height adjustment is based on
the receiver height measurement (distance "d")
determined in Step 1 under "Pivot Plate Hole Position."
A final adjustment of the stand shoe will be made after
attaching the snowplow to the vehicle.
1. Slide the stand shoe into the stand tube and align
the 1/4" hole in the stand tube with the 1/4" hole in
the stand shoe as determined from the table and
illustration.
Stand Shoe Position
Distance "d"
13.0" – 14.5"
14.5" – 16.0"
16.0" – 17.5"
17.5" – 19.0"
Spring Tie
2. Insert a 1/4" roll pin.
3. Do not cut the spring tie until instructed to do so,
after the final stand shoe adjustment.
6
WARNING
Position
1
2
3
4
1/4" Roll Pin
Position 4
Position 3
Position 2
Position 1
July 15, 2020