Douglas Dynamics WESTERN MVP PLUS 75300 Handleiding voor installatie-instructies - Pagina 10

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Douglas Dynamics WESTERN MVP PLUS 75300. Douglas Dynamics WESTERN MVP PLUS 75300 15 pagina's. Snowplow

Pagina afdrukken

OPERATIONAL TEST AND FINAL ADJUSTMENTS

HYDRAULIC UNIT

WARNING

Keep 8' clear of the blade when it is being

raised, lowered, or angled. Do not stand

between vehicle and blade or directly in front

of the blade. If the blade hits or drops on you,

you could be seriously injured.

The MVP PLUS™ snowplow hydraulic unit comes

from the factory pre-assembled, partially filled, and

fully tested.

1. Attach the snowplow to the vehicle according to

the instructions on the back of the blade.

2. Remove and discard the factory‑installed pipe

plug from the top of the reservoir and install the

breather.

Fill Plug

AeroShell

is a registered trademark (

Lit. No. 43174, Rev. 04

Breather

Drain

Cap

) of Shell Oil Company.

To prevent accidental movement of the blade,

always turn the control OFF whenever the

snowplow is not in use. The power indicator

light will turn OFF.

3. Turn the control ON and completely extend and

retract the driver‑side wing several times. Repeat

for the passenger‑side wing. With both wings fully

retracted, raise and lower the snowplow several

times. Activate the control FLOAT function and

manually collapse the lift ram all the way. Turn the

control OFF.

Do not mix different types of hydraulic fluid.

Some fluids are not compatible and may

cause performance problems and product

damage.

4. Remove the fill plug and check the fluid level.

With the snowplow wings and lift ram fully

retracted, the fluid level should reach the fill hole.

If additional fluid is needed, fill the reservoir with

WESTERN

High Performance Hydraulic Fluid

rated to –40°F (–40°C), or other fluid conforming

to Military Specification MIL-H-5606 A, such as

Mobil Aero HFA or Shell AeroShell

NOTE: Loosen fill plug slowly to relieve any

pressure in the reservoir.

NOTE: Add fluid only when all rams are retracted.

5. Replace and tighten the fill plug.

FLUID CAPACITY

• FloStat

Unit Reservoir

• FloStat System Total

WARNING

CAUTION

Fluid 4.

1-3/4 quarts

2-3/8 to 2-3/4 quarts

July 15, 2020