Douglas Dynamics WESTERN ENFORCER 97540 Handleiding voor installatie-instructies - Pagina 10
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Douglas Dynamics WESTERN ENFORCER 97540. Douglas Dynamics WESTERN ENFORCER 97540 19 pagina's. Ultramount 2 snowplow
Pagina afdrukkenOPERATIONAL TEST AND FINAL ADJUSTMENTS
HEADLAMPS
WARNING
Your vehicle must be equipped with snowplow
headlamps and directional lights.
Headlamps, hardware, and instructions are found in
the headlamp box.
1. Install the vehicle wiring according to the
instructions provided.
2. Set the headlamp channel on the lift frame, label
to the front, with the holes aligned.
3. With the correct headlamp on the correct side, set
each headlamp and swivel into place as shown.
4. Secure the headlamps with the correct hardware
for the application as shown below. Inner and
outer posts require different hardware. On LED
headlamps, a rubber washer must be installed
under the slotted holes. Hand tighten.
5. Connect the headlamp wires to the headlamps.
6. Aim the headlamps according to the Snowplow
Headlamp Beam Aiming Instructions
(Lit. No. 27769). Tighten LED headlamp fasteners
to 22 ft‑lb (30 N·m). Tighten halogen headlamp
fasteners to 50 ft‑lb (68 N·m).
Halogen Headlamps
Lit. No. 74914, Rev. 01
7.
From inside the headlamp channel, insert the
cable tie anchors into the holes as shown. The
anchor locking tabs should be horizontal.
Grommet
Cable
Ties
8. For halogen headlamps only, install a split rubber
grommet on each headlamp wire 3" from the
headlamp. Insert the grommet and wire into the
slot on the rear of the channel.
9. Route the wires under the channel and down the
back of the driver‑side vertical support. Secure the
wires to the anchors and the vertical support with
cable ties.
Headlamp
Swivel
Headlamp
Channel
Lift Frame
1/2" Flat
Washers
1/2" Lock
Washers
1/2" Hex Nuts
10
Cable Tie
Anchors
Run harness
underneath
LED Headlamps
Slotted
Hole
1/2" Rubber
Washer
channel.
June 1, 2020