Douglas Dynamics SweepEx Mega-Broom SMB-720 Gebruikershandleiding en installatie-instructies - Pagina 8

Blader online of download pdf Gebruikershandleiding en installatie-instructies voor {categorie_naam} Douglas Dynamics SweepEx Mega-Broom SMB-720. Douglas Dynamics SweepEx Mega-Broom SMB-720 14 pagina's. Modular broom

Pagina afdrukken
INSTALL FORKLIFT POCKETS
ValuSweep
Brooms
®
1. Install forklift pockets on broom hood using 3/8''
hex cap screws.
2. Thread knob through forklift pocket
approximately 1''. Position swivel foot so that
screw can engage locking ring inside the swivel
foot.
3. Use the hood to screw down against to lock both
pieces together. Repeat the process for the other
side.
4. Install one end cap on broom.
5. Insert bristle into broom hood and slide in until it
contacts the end cap.
6. Install other end cap and the broom is ready for
use.
Lit. No. 48166, Rev. 00

ASSEMBLY

Mega-Broom
On the Mega-Broom series, the fork pocket mount is a
broom head. Once the mount is bolted to the broom,
the instructions below should be followed.
The tension of the chain binder should
never be greater than what hand tightening
allows. Never use a pipe or other tool to
gain additional leverage to tighten the chain
binder.
Never over-tension the chain binder—damage
may occur to your person or the product due
to possible "kickback" of the binder.
The Mega-Broom mount comes complete with a set of
chain binders to tighten and securely attach the chains
around the lift truck carriage. Due to the extra weight
and size of the Mega-Broom broom, a positive lock
down is necessary.
8
CAUTION
October 15, 2014