AMPHIBICO PHENOM NX5 SE Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} AMPHIBICO PHENOM NX5 SE. AMPHIBICO PHENOM NX5 SE 14 pagina's. Video camera housing sony hxr-nx5 & sony hdr-ax2000

Pagina afdrukken

OPENING THE HOUSING

Sit the housing on a flat surface. Press and rotate both safety

latches counterclockwise simultaneously until the rear door

opens.

REMOVING THE SADDLE

1. Rotate the saddle locking handle towards the right until it

reaches the end. This will disengage the saddle connector.

2. Use the handle to pull the saddle completely out of the

housing.

SETTING THE CAMCORDER

1. Remove the eyecup and magnifier element.

2. Remove hand strap

3. Rotate and flip the LCD panel to restore it back to the

original position with the LCD screen facing out.

4. Remove MIC Support Holder

- Open support holder to expose the mounting screws.

- Unscrew both screws and remove support holder.

- Replace screws into there mounting holes for safe keeping.

5. Set display output to "ALL OUTPUT" and

set all markers to OFF if using an external monitor

6. Set ND FILTER to OFF

7. Set AUTO LOCK switch to the manual.

8. Audio Settings

- Set Input 1 to MIC

- Set CH1 & CH2 TO "INPUT 1"

- Set audio levels to manual and set dial to level 10 for

maximum hydrophone performance.

PREPARING CAMCORDER & HOUSING

Adjusting the iris

You must first make sure that the iris is set to manual. To do

so, push on the left grip IRIS button while holding down the

shift key. In manual mode, you can adjust the aperture value

of the camcorder by holding down the shift key and turning

the right grip wheel. You can also momenta rely auto iris

when in manual iris by pushing on the MOMENT AI button

located on the left grip.

Adjusting the gain

You must first make sure that the gain is set to manual. To

do so, push on the GAIN button located on the left grip while

holding down the shift key. Once activated, you can adjust

the gain by pushing on the GAIN SELECT button located on

the left grip to select one of its preset gain levels (H,M,L).

Adjusting the shutter speed

You must first make sure that the shutter is set to manual. To

do so, push on the left grip SHUTT. button while holding

down the shift key. In manual mode, you can adjust the

shutter speed of the camcorder by holding down the shift

key and turning the left grip wheel.

Shutter

Wheel

HOUSING & CAMCORDER OPERATION

Left Grip

Trigger Button

(shift key)

Left Grip

Right Grip

Iris Wheel