Dover TWG TULSA WINCH 1200W Servicehandleiding - Pagina 7

Blader online of download pdf Servicehandleiding voor {categorie_naam} Dover TWG TULSA WINCH 1200W. Dover TWG TULSA WINCH 1200W 19 pagina's.

OIL CHANGE

(Item 33)

Gearbox oil is drained by first removing the drain plug

by rotating the drum so that the

(Item 50) (See Fig 1)

plug is visible through the lower hole in the side plate

. Screw in a piece of 1"

pipe to allow the oil to drain, and then with a hex wrench remove the drain plug located inside of

(See Fig. 2)

the 1" pipe

. Examine the used oil for signs of significant metal deposits and then

dispose of it in a proper manner. Remove the 1" pipe.

Rotate the drum so that the port is visible through the upper hole in the side plate

Install a 1" pipe

(See Fig. 3)

with elbow through the upper hole in the side plate

. Fill the gearbox with 1.00 quart of

(Item 33)

See the Oil Chart on page

EP-90 oil. Remove the pipe and elbow then replace the plug

6 of this manual for the recommended oil type and grade for your application.

(Item 40)

Drain the brake section by removing the drain plug

under the motor along with the vent

(Item 30)

(See Fig. 4)

above the motor

. Inspect the oil for signs of metallic particles and/or burning

(Item 30). See Oil

and reinstall the drain plug. Fill with ¼ quart of non-EP oil and reinstall the vent

Chart Pg. 6 this manual for recommended oil type and grade for your application.

WIRE ROPE

Wire rope should be installed as shown in the drawing below. Note that the wedge will satisfy cable

diameters from 7/16" to 5/8", depending on how it is installed in the cable drum.