Dover HYDRO HYDSPD0093 Gebruikershandleiding - Pagina 18

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dover HYDRO HYDSPD0093. Dover HYDRO HYDSPD0093 20 pagina's. With evoclean

4.OO operation

4.O1 Start-Up

After having installed the unit, carry out the start-up by following the steps below.

Previous requirement and unit configuration

Make sure that the laundry is created in Hydro Connect and the equipment is registered in it. In this way the obtaining of

statistical data will be enabled. Start the equipment through the side switch. The service pilot will light.

4.O2 Prime Product Delivery Tubes

First, all the outlet pipes must be filled with water. To do this access the calibration screen and use the 'Water' selection in the

calibration mode. After filling all the tubing, check that there are no leaks, then continue with the start-up.

Prime the suction tubes of each product

We have to fill each tube that goes from the suction rod to the pumps using the calibration screen as in the previous step.

In this case, we will select 'Product' as the calibration mode. After priming each tube, the channel must be cleaned. It is

important to take into account the chemical incompatibilities choosing the order of the products to be primed.

4.O3 Calibrate the products

You must keep 'Product' on the calibration screen. As described in section 3.12, we will select each product and press the

calibration button sending the dosage to a washing machine. After determining the amount of chemical dosed, enter that

volume into the calibration screen.

4.O4 Calibrate the water.

The water must be calibrated to the furthest washing machine.

4.O5 Check the dosage

To be sure that the meter works correctly, we can perform manual dosages and take a sample. The amount obtained must be

the same as the estimated amount that appears on the screen.

The manual dosages have to be done without the flush, which involves doing a channel cleaning.

4.O6 Adjust the flush of each washing machine

The user has to execute manual dosages to each washing machine. It is advisable to choose a product with a visible color.

Looking at the entrance of the washing machine, we can know if the configured flush is enough to send the product inside. If

we want to modify the water flush, we can go to the washing extractor parameters screen to do it.

4.O7 Start each washing machine and check signals

If the signals of the washing machines are connected correctly, we will activate them one by one to verify the signal reception.

The formula number and the corresponding phases must be seen on the 'View washing machines' screen.