Amphony L1500 Gebruikers- en installatiehandleiding - Pagina 11
Blader online of download pdf Gebruikers- en installatiehandleiding voor {categorie_naam} Amphony L1500. Amphony L1500 17 pagina's. 5.8 ghz digital wireless transmitter/amplifier/receivers & headphones
Ook voor Amphony L1500: Productinformatie (4 pagina's), Specificaties (4 pagina's)
Pagina afdrukkenUser and Installation Guide
Troubleshooting
Problem
The transmit light
does not go on after
DC power is applied
to the transmitter
The transmit light
goes out after a few
seconds and does
not light again
No audio at receiver
Audio is distorted
Speaker audio level
is too low
Page 10
Possible Cause
Faulty AC adapter
or faulty power outlet
No audio present at
audio input
Transmitter hung up
Faulty AC adapter
or faulty power outlet
Transmitter volum e
control set too low
Strong interferenc e
Transmitter volum e
control set too high
Strong interferenc e
Transmitter volum e
control set too low
Speaker volume
control set too low
Audio signal too
weak
Solution
Check the power outlet and
the AC adapter; if possible,
check for correct voltage of
the AC adapter.
Check the audio connection
to the transmitter and ensure
that there is audio present.
Disconnect and then
reconnect DC power.
See under "Faulty AC adapter
or faulty power outlet" above.
Adjust the transmitter volume
control.
See under "Strong
Interferenc e" on next page.
Adjust the transmitter volume
control until clipping stops.
See under "Strong
Interferenc e" on next page.
Adjust the transmitter volume
control to achiev e the desir ed
audio level.
Adjust the speaker volum e
control to achiev e the desir ed
audio level.
Increase the output level of
the audio source (connect
transm itter to an adjustabl e
output by using an adapter if
necessary).
R R