Combi Counterpart 2 Gebruiksaanwijzing - Pagina 7
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Combi Counterpart 2. Combi Counterpart 2 13 pagina's.
Pagina afdrukken
Removing/Attaching the Seat Cushion
Seat Base
Hook & loop
fastener
Removing Rear Seat Cushion
1. Unzip the side of the seat
cover from both sides
of the stroller armrest.
(figure 5 & 6)
2. Follow instructions for
Removing Front Seat
Cushion.
Attaching Seat Cushions: Reverse the directions for removing.
Using the Travel System
Use only the Combi
Shuttle or Combi Connection
infant carrier with this stroller.
When the infant carrier is
attached, ALWAYS ensure it
is secure by pulling up on the
handle.
DO NOT carry the stroller
by using the infant carriers
handle.
ALWAYS secure your child
with the infant carriers 5-point
harness before using it with
the stroller.
- 7 -
Removing Front Seat Cushion
1. Press levers down on right
and left harness hooks to
detach hooks from buckle
tongues.
2. Press buckle button down
(with Combi logo) and
detach buckle tongues from
buckle.
3. Remove shoulder pads
from harness by pulling
over harness
hooks.
(figure 5)
Carrier Attachments (figure
7) must be attached to the
front of the stroller before
attaching the Combi Shuttle
infant carrier. DO NOT use
carrier attachments with the
Combi Connection infant
carrier.
To ensure your child's
safety, please refer to the
infant carriers instruction
manual before using it with
this stroller.
When the Connection
infant carrier is attached
to the stroller in the rear
position the front seat must
be completely upright.
If unable to securely
attach the infant carrier to
your stroller, discontinue use
and contact Combi Consumer
Affairs.
CAUTION
If seat cushion is ripped or torn,
do not use.
Do not use the stroller without
the seat cushion.
4. Pull top of seat pad forward to
detach hook & loop fastener..
5. Pull all the harness straps
through the top and side slots in
cover.
6. Unzip zipper at the base of the
seat cover.
7. Pull bottom of seat pad upward
to detach hook & loop fastener
(figure 6)
Shuttle Attachments