CombiSteel 7054 series Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} CombiSteel 7054 series. CombiSteel 7054 series 16 pagina's. Dough roller
Ook voor CombiSteel 7054 series: Gebruikershandleiding (14 pagina's)

Pagina afdrukken

This data is for informational purposes only.

CLEANING AND HYGIENE

1. Start cleaning your machine after you have finished with it and do the cleaning while your machine is

inoperative.

2. Always disconnect the machine from the mains before cleaning.

3. Clean the machine parts with soapy hot water and dry immediately.

4. Make sure that these parts do not remain wet.

5. Never wash the machine with pressurized water.

6. Never attempt to clean the machine while it is in operation.

7. Start the machine again after it is completely dry.

TROUBLESHOOTING

Fault

The appliance is not

operating

The appliance makes

metallic sounds

WARRANTY

7054 Series Vegetable Chopping Machines are under warranty for 1 year against manufacturing defects of

machines covering defects in the goods, hidden defects in workmanship and/or hidden defects in material.

Warranty is invalid in case of failure due to violating rules specified in operation instructions. Combisteel BV is

not responsible for any damage or loss that may occur due to operational fault.

Combisteel BV, reserves the rights to change any products without notice. Technical data, drawings, scales,

working capacities and illustrations for informative purposes only. The manufacturer shall not be liable for any

typographical errors that may occur.

Do not attempt to open the cover while your machine is running.

Switch off the power and unplug your machine before cleaning.

Never attempt to clean the machine while it is in operation.

Never wash the machine with pressurized water.

Possible cause

The plug may not be connected

The machine may be out of power supply

Foreign material may get in the machine

The machine may be damaged

Plug cable may be torn and/or there may

be lack of phase

www.combisteel.com

Actions to be taken

Connect the plug to power supply

Check the power supply

Stop the machine, cut the power

supply and check whether there is or

not foreign material

Stop the machine, cut the power

supply and check all the surfaces

Open the cable and check if there is

any fault if necessary