Downeaster 3050 Gebruiksaanwijzing - Pagina 2

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Downeaster 3050. Downeaster 3050 2 pagina's. Rainfall instrument

Rainfall Instrument

-Medallion & Classic Series-

The rain collector sends a signal to the rainfall meter of .01 inch of

rain for every 'tip' of the rain mechanism located inside the rain

collector. There is no need to empty the rain bucket as it is self-

emptying. Freezing weather will not damage the collector, however

the readings will be inaccurate. Every few months, clean the

strainer of leaves and other debris to keep the readings accurate.

BOX CONTENTS:

1 - Rainfall Instrument

1 - Rain collector, self-tipping with 60' of wire

1 - 6Volt AC Power Supply

TO INSTALL:

1-Place the collector on the base, line up the screw holes and

tighten until snug. *DON'T OVER TIGHTEN*

2-Remove the shipping tape from the screen

3-Mount the collector on a flat, level surface in an open area with

NO over-hanging obstructions

4-Mount the bucket base using the 4 screws provided

5-Run the wire from the bucket to the location of the Rainfall

Instrument.

6-Run the wire through a conduit if it needs to go underground

7-At the rear of the instrument, connect a new 9Volt battery to the

two terminals at the TOP

8-Connect the wire from the rain collector to the two terminals on

the BOTTOM LEFT

9- (Optional) Connect the 6Volt AC power supply wires to the

terminals on the BOTTOM RIGHT. During a power outage the

instrument will switch to battery back up and run off the 9Volt

battery for about 48 Hours before losing its memory.

INSTRUMENT IS FACTORY CALIBRATED: ALTERING IT

IN ANY WAY WILL VOID YOUR WARRANTY

TO OPERATE:

The LEFT button (as you face the instrument) switches the reading

from CURRENT to ANNUAL.

The RIGHT button the RESET button.

Push and hold for 5 seconds to reset the CURRENT or ANNUAL

reading, and the digital display will start again at 0.

Be sure the instrument is showing the reading you want to reset

BEFORE you push and hold the Reset button! If you want to clear

the 'Current' memory, make sure the instrument is showing the

'Current' reading and the 'Current' light is on, THEN push and hold

the RESET button. You don't want to clear the wrong reading, you

can't get it back!

Please call with any questions regarding installation or operation of

this instrument.