Downee mhouse SL1s Korte instructies - Pagina 2

Blader online of download pdf Korte instructies voor {categorie_naam} Downee mhouse SL1s. Downee mhouse SL1s 3 pagina's. Slide motor

Pagina afdrukken
The SL1s suits residential gates up
to 5m long, weighing up to 400kg
(effective gate weight).
Automation only works if the gate
is in good condition, runs freely for
the full length.
MOTOR POSITION
The motor needs to sit on a solid
footing on the opening side of the
gate. The edge of the base plate
should be 50mm from the inside of
the gate.
Secure the motor with 100mm M8
dyna-bolts. It's crucial that the motor
cannot move. If uneven, the motor
can be levelled up by adjustment of
the allen-headed bolts in each corner
of the motor.
GEAR RACK
1.
Unlock the motor with the release-key.
2.
Lay the gear-rack on the ground next to the gate. Check that the mounting points of the gear-rack
are not positioned so that conflict with the wheels of the gate, and the ends of the gear-rack are
supported on the gate.
Fix the gear-rack to the gate, one length at a time, using the motor as a guide for the height.
3.
Leave a play of 1 mm between the rack and the pinion so that the gate does not weigh on the
gear.
Once the full length of the gear-rack is attached, manually move the gate backwards and for-
4.
wards to check that there are no tight or lose sections on the gear-rack, and adjust accordingly.
If you are installing a full kit, connect any other devices as shown in the Installation Instructions.
GATE
(not supplied)