AmpliVox TITAN Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AmpliVox TITAN. AmpliVox TITAN 8 pagina's. Wireless portable pa

Pagina afdrukken

Channel and Microphone Specifi cations

Channel Specifi cations (Wireless Frequency Channel)

Carrier Frequency

Range

Stability

Deviation

+/- 40KHz, with level Limiting circuit control

Dynamic range

S/N Ratio

T.H.D.

Squelch Circuit

Pilotone squelch / PLL Synthesized Receiver / Non-Diversity

Frequency Response

Receiver Mode

Wireless Microphone

Single Receiver/Non-Diversity or PLL System

Capsule Type

Wireless Transmitter

Dynamic Capsule or Condenser Capsule Approx 10mW

Ratio

Transmitter Battery

Microphone Specifi cations

Carrier frequency range

Pre-programmed Frequency

Frequency stability

Frequency response

Antenna

Battery

Weight

Amplivox Sound Systems

- Call 800-267-5486 for assistance - www.ampli.com for support and registration-

UHF 600-960MHz

+/- 0.005%

>110dB

>105dB

<0.5%

50Hz~18KHz63dB

Quartz and Tone Squelch True Diversity/

AA No 3 Batteries (2 pcs) / 9V Battery (1pc)

600-960MHz

Preset 16 Channels

<0.005%

50Hz-18KHz( ± 3dB)

External antenna

1.5v x 2 or 1.2V x 2(AA UM-3)

3.4 ozs

Special Notes & Troubleshooting Guide

Note On Unit Installation

1. For best sound projection unit should be placed on raised surface or tripod 4-6

feet above the fl oor.

2. When turning on the system initially, volume should be set to lowest settings,

and raised as needed.

3. The battery charge light will blink green when the batteries are charging, but

will remain steady once fully charged.

4. If there is poor wireless microphone reception (crackling, buzzing or cutting in

and out), change the channels on the main unit and wireless microphone to one

of the other available 16 channels. There may be interference on the channel

your operating on. It is also a likely possibility that the microphone's batteries

need recharged/replaced if wireless signal is weak.

5. If adding your own external speaker, the requirements are 4Ω/80W. Failure to

meet these requirements may result in poor audio, or excessive feedback.

Troubleshooting Guide

1. Make sure battery's positive side faces up when changing the remote control

batteries, and observe the correct insertion direction (positive/negative) for the

system's and microphone's rechargeable batteries before calling for support.

2. Turn unit off while not in use and remove batteries if unit is to be left unused for

a long period of time.

3. Operating time depends on volume. When the green signal is steady (not fl ash-

ing) battery is fully charged. If indicator is fl ashing unit can receive charge. If

charge is very low the indicator will remain off . Please recharge as soon as pos-

sible. You may need to plug into external power source at this point.

4. To keep batteries in optimal condition, please charge once every 2-3 months.

Note on Unit:

1. Do not open this unit, or alter its components in any way. Doing so voids your

warranty, and can result in electrocution or unit damage. You alone are liable if

anything occurs when servicing the unit yourself.

2. Be careful not to drop or jar the unit severely. Damage may occur, and this type

of abuse is not covered by the warranty.

3. Do not leave the unit exposed to the heat and direct sunlight for prolonged

periods of time. Heat may damage the unit.

4. Do not use wheels in mud, stone or poor ground conditions to avoid any dam-

age to wheel assembly.

10/30/2009

Amplivox Sound Systems

- Call 800-267-5486 for assistance - www.ampli.com for support and registration-

10/30/2009