AmpliVox S505a-BK Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AmpliVox S505a-BK. AmpliVox S505a-BK 4 pagina's. Executive adjustable column sound lectern

Pagina afdrukken

NO TOOL ASSEMBLY OF LECTERN

Please read all instructions first and then follow the steps below.

Your lectern may not contain all of these features.

BASE ASSEMBLY

1. Remove center column from the

shipping carton and place as

shipped (speakers face down) on

the floor or on a suitable sturdy

table. If assembling on floor, raise

bottom end of lectern to make fas-

tening base to lectern easier.

2. Remove and unpack the base from the

shipping carton.

3. Position base with the two locking

wheels facing the back of the lectern.

Assemble the base to the column by

using four of the 2 inch long knurl knob

screws supplied with the lectern.

TIP: Do not completely tighten each

screw as you place it through the base

and into the column. Wait until all four

screws have been put into the proper

position and then tighten them up.

4. Turn the base and column assembly

upright. If assembled on a table, place

the unit upright on the floor.

READING TABLE ASSEMBLY

1. Remove and unpack the lectern read-

ing table.

2. Attach the table to the top of the col-

umn. This is accomplished by placing

the table top on the column base and

lining up the corners.

TIP: the corners need to be lined up in

order to get the screws in the table top.

3. Fasten the reading table to the column

with the 4 - 1 inch long knurl knob

screws supplied. The knob screw goes

up into the reading table through the 4

holes in the column

SPEAKER GRILLE

Remove and unpack the speaker

grille..

Attach the speaker grille to the front of

the lectern by pushing the plastic posts

in each corner of the grille into the 4

cups.

MOUNTING FLANGE

READING

TABLE

CENTER

COLUMN

BASE

ASSEMBLY OF FLEXIBLE GOOSENEC MICROPHONE

The MIC CORD comes pre-wired to the amplifi-

er but needs to be assembled into the MOUNT-

ING FLANGE located in the far left corner of the

READING TABLE .

Take the plug end of the microphone cable and

insert into the rubber boot of the MOUNTING

FLANGE from underneath. Push plug end all

the way through the rubber boot.

Now take GOOSENECK MICROPHONE

and connect to the plug end of the ca-

ble. Notice that the microphone connect-

or has three small (3) pins inside of the

connector. These pins can bend if you

are not careful. Align these pins with

the three (3) holes in the plug end of the

cable and push together until microphone

is completely seated onto the plug.

Now carefully take excess cable and

push back through rubber booth first,

then insert the microphone only far

enough that it is able to stand upright

without falling over.

OPERATION OF ADJUSTABLE LECTERN

This lectern adjusts from 38 inches to 44 inches measured from the

amplifier side. To adjust the lectern height:

1. With one hand flat in the center of the table holding it down

loosen the adjustable height knob with the other hand.

2. You may extend the lectern up to its maximum height of 44 inches.

3. To lower the lectern, lightly press down on the reading table

until the desired height is reached and retighten the

height-locking knob.

TIP: The knob locks at any height by tightening it. The lectern

will adjust from 44 inches down to 38 inches when

measured from the amplifier side.

FLEXIBLE GOOSENECK

MICROPHONE

CONTROL PANEL

ADJUSTABLE HEIGHT DIAL

USE TO ADJUST LECTERN

HEIGHT FROM

INCHES