Follett F505A/W Bedienings-, onderhouds- en onderdelenhandleiding - Pagina 10

Blader online of download pdf Bedienings-, onderhouds- en onderdelenhandleiding voor {categorie_naam} Follett F505A/W. Follett F505A/W 17 pagina's. Ice and water dispenser
Ook voor Follett F505A/W: Installatiehandleiding (13 pagina's)

Pagina afdrukken

Ice transport tube replacement – models F255A/W, F505A/W, C25R5A/W, C50R5A/W

Correct installation of ice transport tube is critical to remote icemaker performance.

Replacement ice transport tubes for remote icemakers must be insulated and run continuously

from icemaker to dispenser with no dips or bends with a radius of less than 6"(153mm).

1. Remove top and rear access panel from dispenser (and lower front panel on freestanding unit).

2. Disconnect existing ice tube from engaging pin in ice storage bin and pull down through dispenser chase.

3. Disconnect opposite end of tube from icemaker.

4. Run end of new ice transport tube with 3/16" (5mm) hole through right hand knockout in back of dispenser or through

counter into bottom of dispenser, being careful to avoid any bends with less than 6" (153mm) radius.

5. Insert tube in internal chase in rear inside corner of dispenser (right side as you face rear of dispenser) and push up

into storage area.

6. Push the 3/16" hole near end of tube into pin on ice tube bracket (see drawing below).

Steps 7-8 for units with remote icemakers

7. Install supplied insulation to run of transport tube required

for your site, leaving approximately 2" (51mm) of tube

exposed at free end.

8. Check that insulated tube runs continuously to dispenser

with no dips.

All units

9. Place free end of tube in a cup of hot water to soften, slip

supplied hose clamp onto tube and push tube onto exit

port of evaporator. DO NOT TWIST HOSE WHEN

SECURING TO EVAPORATOR.

10. Fasten tube on port with hose clamp, being sure that

clamp is positioned on evaporator side of flange.

11. Tighten clamp.

only

capillary

tube

ice tube

bracket

(5mm)

hole in

ice tube

New Style Bracket

Section A – A

(26mm)

engaging pin

3/16"

ice

tube

Back wall

.1875" (5mm)

dia. hole

(26mm)