Follett H25R5A/W Bedienings-, onderhouds- en onderdelenhandleiding - Pagina 9
Blader online of download pdf Bedienings-, onderhouds- en onderdelenhandleiding voor {categorie_naam} Follett H25R5A/W. Follett H25R5A/W 17 pagina's. Ice and water dispenser
Ook voor Follett H25R5A/W: Installatiehandleiding (13 pagina's)
Pagina afdrukken- 1. Operation
- 2. Troubleshooting
- 3. Before Calling for Service
- 4. Troubleshooting Sensorsafe Board and Sensors
- 5. Wiring Diagrams
- 6. Dispense Chute and Splash Panel Areas - Lever Models
- 7. Dispense Chute and Splash Panel Areas - Sensorsafe Models
- 8. Wheel Motor and Drive System
- 9. Hopper Components
- 10. Solenoid Dispense Assembly
Thermostat locations – C25T5A/W, H25T5A/W, C50T5A/W, H50T5A/W
hand bend
cap tube
end to
approx. 45˚
as shown in
Detail A–A.
Thermostat locations – C25R5A/W, H25R5A/W, F255A/W
Ice transport tube replacement - C25T5A/W, H25T5A/W, C50T5A/W, H50T5A/W
If preparing tubing not supplied by Follett, dispenser
!
end of tube must be fitted with mounting pins as
shown in drawing at right.
1. Slip hose clamp on end of transport tube without pins, immerse this end
in cup of hot water to soften hose and push it on evaporator port of
icemaker.
2. Fasten tube on evaporator port with hose clamp, being sure that clamp
is positioned on evaporator side of flange. Tighten clamp.
3. Insert loose end of the ice tube into bracket on icemaker base as
shown in drawing.
4. Pull up on ice tube to seat the pins in bracket.
NC
C50R5A/W, H50R5A/W, F505A/W
NC
bin thermostat
bin thermostat
ice tube
bracket
icemaker
base
9
Detail A–A
Approx.
3/4" (1.9cm)
45˚
bend
ice tube
mounting pin
plate
gasket
cap tube
bracket
ice
deflector