FOLLO FUTURA FOLLO STABILIS MANUPED Handmatig - Pagina 8
Blader online of download pdf Handmatig voor {categorie_naam} FOLLO FUTURA FOLLO STABILIS MANUPED. FOLLO FUTURA FOLLO STABILIS MANUPED 13 pagina's.
Pagina afdrukken
7. Moving / transporting the
machine: When the machine is
to be moved or re-positioned
indoors, the easiest method is
to move it on its transport
wheels. Tilt the machine
forwards onto its wheels as
shown in the drawing. The
machine can then be moved
and positioned with ease. If the
machine is to be transported
over longer distances, it is easy
to fold up. Push the floor plates
fully in and fold down the main
beam as shown in the
illustration in the UNPACKING
section. The machine takes up
little space and is easy to carry.
Maintenance
Inspect the machine regularly for damage, play or missing parts. In the case of damage or
other deficiencies, the machine must not be used until it has been repaired.
Troubleshooting
Counter / computer:
If the counter stops working (empty display), check the battery first. If the counter is
working, but does not count, check that the black transmitter on the largest nickel
plated disc (No. 44 on the parts drawing) is in position. Check also that the opening
between the black transmitter and the sensor (immediately below the computer) is
correct when they pass each other. The opening must be between 2 and 4 millimetres
(maximum 5 millimetres). Adjust the opening by carefully bending the baseplate to
which the sensor is attached. See also the folder that accompanied the computer.
Brake resistance:
If no brake resistance is felt or the resistance is not functioning properly, the handle
may have been adjusted too far in the wrong direction (several turns). Turn the handle
clockwise until heavy resistance is felt. Then adjust to the required resistance. If
resistance is uneven, inspect the brake lining (No. 46 on the parts drawing). If the
brake lining has loosened, it must be replaced.
Gas-assisted spring:
If the gas-assisted spring in the adjustment strut is not functioning properly, try giving it
manual assistance (up or down). This may help if the spring has seized in position.
If the gas-assisted spring does not lock in position when the lever is released, the spring
must be adjusted. Unscrew the gas spring's upper attachment point (Nos. 58+29 on the
parts drawing). Loosen the nut on the gas spring strut (immediately below the lock/unlock
handle) and move the attachment (No. 28) upwards slightly until the lever is functioning
properly.
If the gas-assisted spring does not function when the lever is depressed, proceed as
described above, but move the attachment point (No. 28) in the opposite direction to
adjust.
If these guidelines fail to rectify the situation or if there are other faults or deficiencies, contact
your dealer for replacement parts or for service.
NB! The manufacturer responsibility for CE marking is invalidated if any form of
modification is carried out.
Extra equipment
-Comfort discs for handles
-Gloves for handles
-Large pedals
Technical specifications
Weight
20,9 / 14,5
Width:
with/without
kg
floor plates:
Height:
110 cm
Recycling
This machine is comprised mainly of steel, rubber and plastic. When separating for recycling,
the handles, pedals, drive belt and plastic covers must be handled as hazardous waste. The
remaining parts of the machine can be handled as metal.
The "CE" mark indicates that this product conforms with European standards
for health, safety and the environment.
77 cm
Length
114 / 56
with/without
cm
floor plates:
08/08/18
Side 8
rev: 18