CARBONE TG109136-8 Handmatig - Pagina 5

Blader online of download pdf Handmatig voor {categorie_naam} CARBONE TG109136-8. CARBONE TG109136-8 9 pagina's.

Pagina afdrukken

Operation

Changing rotational direction (see Dia6)

To change the rotational direction, push the

forward/reverse selector switch to the "R"

position indicated on your drill. The rotation

will now be forward rotation. Push the

forward/reverse selector switch to "L" position

indicated on your drill. The rotation will be

reverse rotation.

Note: Never move the forward/reverse

switch whilst the drill in operation or the

on/off switch is locked as this will damage

the drill.

Drill/Impact action switch (see Dia7)

When drilling masonry and concrete push

the drill/impact action selector switch into the

hammer position "

". When drilling wood,

metal, plastic push the switch into the drill

position " ".

Dia6

Dia 7

Maintenance and Troubleshooting

Working hints for your drill

1 Drilling masonry and concrete

Select the drill/impact action selector switch to the "hammer symbol" position.

Tungsten carbide drill bits should always be used for drilling masonry,

concrete etc with a high speed.

2 Drilling steel

Select the drill/impact action selector switch to the "drill symbol" position. HSS

drill bits should always be used for drilling steel with a lower speed.

3 Screw driving

Select the drill/impact action selector switch to the "drill symbol" position.

Use a low speed to drive in or remove screws.

4 Pilot holes

When drilling a large hole in tough material (i.e. steel), we recommend drilling

a small pilot hole first before using a large drill bit.

5 Drilling tiles

Select the drill/impact action selector switch to the "drill symbol" position to

drill the tile. When tile has been penetrated, switch over to "hammer symbol"

position.

6 Cool the motor

If your power tool becomes too hot, set the speed to maximum and run no load

for 2-3 minutes to cool the motor.

Maintenance

1 Your power tool requires no additional lubrication or maintenance. There are

no user serviceable parts in your power tool.

2 Never use water or chemical cleaners to clean your power tool. Wipe clean

with a dry cloth.

3 Always store your power tool in a dry place.

4 Keep the motor ventilation slots clean.

5 If you see some sparks flashing in the ventilation slots, this is normal and will

not damage your power tool.

6 If the supply cord is damaged, it must be replaced by a special cord or

assembly available from the manufacturer or its service agent.

Troubleshooting

1 If your drill will not operate, check the power at the mains plug.

2 If the drill is not cutting properly, check the drill bit for sharpness, replace

drill bit if worn. Check that the drill is set to forward rotation for normal use.

3 If a fault can not be rectified return the drill to qualified repair personel for service.