AMS AS5047D-TS-EK-AB Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} AMS AS5047D-TS-EK-AB. AMS AS5047D-TS-EK-AB 8 pagina's. Standard board

AS5x47 Standard Board

Install the AS5x47 Demo Software

The Software is located on the USB drive that comes with the USB I&P Box or it can be

downloaded from ams webpage. After Installation run the software.

Assemble the Hardware Setup

Follow the Instructions shown below in

Figure 1:

Setup Instructions

Note: It might be necessary to perform a firmware update on the USB I&P Box if a wrong firmware

was detected. In this case, the user will be prompted to allow an automatic firmware upgrade.

3rd Start using the software

Following parts of the software are used to perform a configuration and to read-out the AS5600.

Refer to

Figure 2

for reference. Read the software user manual for details.

A. Perform your desired settings

B. Read/Write/Burn/Export or Import your configuration

C. Verify the results

ams Eval Kit Manual

[v1-00] 2014-Jul-02

Figure 1

A. Short J1 on the adapterboard to set-up the 3V3 mode

B. Connect the USB I&P Box with the AS5x47_EK_AB using the

10-way cable

C. Place the RMH05 over the adapterboard

D. Connect the USB I&P Box using the USB cable to Computer.

The USB device is detected in Windows and by the AS5x47

Demo Software. The setup is ready for demonstration.

VDD

SPI-CS(0)

Index

SPI-CLK

SPI-MOSI

SPI-MISO

GND

to set-up the kit.

USB

Page 4

Document Feedback