DR Power Equipment PILOT 2C Veiligheids- en bedieningshandleiding - Pagina 8
Blader online of download pdf Veiligheids- en bedieningshandleiding voor {categorie_naam} DR Power Equipment PILOT 2C. DR Power Equipment PILOT 2C 20 pagina's. 2-cycle tiller cultivator
Pagina afdrukken
Assembling the Machine
Stabilize the shipping carton on a flat ground surface before attempting to unpack and assemble the machine. Do not place the
machine on a bench or table where it can fall and cause personal injury or damage the machine.
Middle
Handlebar
Lower
Handlebar
Figure 2
Throttle
Lever
Middle
Upper Right
Handlebar
Handlebar
Cable
Tie
Figure 3
Drag
Stake
Point
Facing
Forward
Figure 4
®
DR
8
2-CYCLE TILLER CULTIVATOR
Parts Supplied in Shipping Carton:
T-Handle
Nut
Handle
Clamp
Bolt
Curved
Washer
Note: Use care with the Upper Right Handlebar so as not to kink the Throttle
1. Place unit upright with the Tines and Wheels on level surface. Set Wheels to
Upper Left
2. Assemble the Middle Handlebar to the Lower Handlebar (already attached to
Handlebar
T-Handle Nut,
Curved Washer,
and Handle
Note: You can install the Middle Handlebar in either of two positions, one high, and
Clamp Bolt
3. Attach the Upper Right (with Throttle Lever) and Left Handlebars to the
4. Secure the Throttle Cable to the Upper Right Handlebar with a Cable Tie.
5. The Drag Stake shipped with its pointed end facing upwards. Remove the
Lock Pin
6. Do not discard your packaging material until you are fully satisfied with your
DR 2-CYCLE TILLER CULTIVATOR
Upper Left Handlebar
Upper Right Handlebar
Middle Handlebar
Safety & Operating Instructions Manual
Engine Manual
Hardware Bag:
(4) T-Handle Nut
(4) Curved Washer
(4) Handle Clamp Bolt
(1) Cable Tie
Cable; it is pre-attached to the Engine.
lowest position.
the machine) using two T-Handle Nuts, two Handle Clamp Bolts and two
Curved Washers (Figure 2). The Middle handlebar can be installed in high or
low position.
one low. DO NOT over tighten the T-Handle Nuts.
Middle Handlebar using the remaining two T-Handle Nuts, two Handle
Clamp Bolts, and two Curved Washers (Figure 3). DO NOT over tighten the
T-Handle Nuts.
Lock Pin, turn the Drag Stake around and direct the point in the downward
position facing towards the Tines, and then reinsert the Lock Pin (Figure 4).
new DR 2-CYCLE TILLER CULTIVATOR.