DR Power Equipment PTO POST HOLE DIGGER Veiligheids- en bedieningshandleiding - Pagina 12

Blader online of download pdf Veiligheids- en bedieningshandleiding voor {categorie_naam} DR Power Equipment PTO POST HOLE DIGGER. DR Power Equipment PTO POST HOLE DIGGER 16 pagina's.

Pagina afdrukken

Figure 15

Inner Cutting

Edge

Figure 16

PTO POST HOLE DIGGER

Adding Oil to the Gearbox

Tool and Supplies Needed:

Oil Fill

•

Plug

S.A.E. 80W/90 or S.A.E. 85W/140 Multi-purpose Gear Oil

•

10mm Allen Wrench

•

6mm Wrench

•

Clean Rags

Note: Ensure that the Gearbox is Level when adding oil to ensure an accurate

Overflow

reading.

Plug

1. Remove the Oil Fill Plug from the top of the Gearbox using a 10mm Allen

Wrench (Figure 15).

2. Remove the Overflow Plug from the side of the Gearbox using a 6mm Allen

Wrench

3. Slowly add oil to the top of the Gearbox until it starts draining from the

overflow hole. Allow a few seconds for the oil to settle to get an accurate

reading.

4. Reinstall the Overflow Plug into the side hole.

5. Reinstall the Gearbox Plug into the top of the Gearbox.

Replacing the Cutting Edges

Tools and Supplies Needed:

Carriage Bolts

and Locknuts

•

9/16 Wrench

•

Gloves

1. Clean any Dirt/Debris away from the damaged or Worn Cutting Edges.

2. Remove the two Carriage Bolts and Locknuts that secure each Cutting Edge

to the Auger using a 9/16" Wrench (Figure 16).

Outer Cutting

Note: 9" and 12" Augers have Inner and Outer Cutting Edges (one of each). 6"

Edge

Augers have two of the same Cutting Edges. For Best performance, always replace

both Cutting Edges at the same time.

3. Position the new Cutting Edge on the underside of the Auger with the

Beveled Edge facing up(Figure 16). Reinstall the two Carriage Bolts and

Locknuts and tighten them using a 9/16" Wrench.

4. Repeat Step 3 for the other Cutting Edge.