AmScope AM-1 Series Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AmScope AM-1 Series. AmScope AM-1 Series 19 pagina's.

SM-1 Series

1. Once you have placed your sample on the table or base below the objective, center the sample as best

as possible. A slide is neither needed nor required for a stereo microscope, although they can be used if

desired. If using a slide, use the stage clips to hold it in place.

2. With both eyes open, look into the eyepieces. Adjust the

interpupillary distance by holding the eyepiece tubes and rotating

the eyepiece tubes either towards or away from each other until

only one circle of light is seen by both eyes.

3. Adjust the magnification knob to the lowest setting (0.7) and

move the microscope's focusing knobs (on the focusing rack) to

adjust the height of the unit until at approximately 4 inches

(101mm) away from the sample. If not clear after adjusting,

please be sure that you have not installed any additional Barlow

lenses onto the objective.

4. Center the object in the field of view once you have achieved focus.

1. A stereo microscope's focus differs from a compound microscope. Magnification and focal distance

(working distance) are inversely related to each other. The more magnified one is, the lower the

distance between the objective and the sample to achieve focus.

2. When first using the microscope, remove all Barlow lenses and set the magnification knob (on the

microscope head) to the minimum setting (0.7x).

3. Begin focusing the microscope by moving the knob until the head is about 4 inches (101mm)

away from the sample. This should bring the microscope in focus at 7x.

4. If you' d like to use greater magnification than the minimum setting, you will need to move the

microscope head closer to the sample as well as adjust the magnification knob to a higher setting. The

more magnified, the closer you need to be.

5. If you've achieved the maximum magnification (45x and 3/16 of an inch or 4.76mm) on the

microscope, you can use other accessories to either further increase or further decrease the

magnification, called Barlow lenses. These lenses screw onto the objective to either amplify or reduce

the total magnification.

Operation