Bosch 9000416647(8811) Gebruiksaanwijzing - Pagina 15

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Bosch 9000416647(8811). Bosch 9000416647(8811) 26 pagina's.

Pagina afdrukken

Timer programming *

* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
Open the door.
Switch on ON/OFF switch
Press
+ button until the digital
5
display
jumps to
8
Press
+ or – button until the
5
displayed time corresponds with
your requirements.
Press START button
programming is activated.
To delete timer programming, press
the
+ or – button until
5
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
Close the door.

End of programme

The programme has ended when the
value
is indicated on the numerical
display
.
8
The end of the programme is also
indicated by an acoustic signal.
This function can be changed as follows:
Open the door.
Switch on ON/OFF switch
Hold down programme button A
and press START button
the digital display
Release both buttons.
Press programme button A until the
factory set value
the digital display .
To change the setting,
press programme button C .
Each time the button is pressed, the set
value increases by one level; when the
value of
has been reached, the
display jumps back to
Press START button
is saved.
Close the door.
.
1
.
, timer
7
.
1
until on
7
is indicated.
is indicated on
(off).
, the set value
7

Switching off the appliance

Short time after the end of the programme:
Open the door.
Switch off ON/OFF switch
Turn off the tap (not applicable
if Aqua-Stop fitted).
Remove the utensils when they have
cooled down.
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.

Interrupting the programme

Open the door.
Switch off ON/OFF switch
The LEDs go out. The programme
is saved.
If the door was opened on an appliance
which has a warm water connection
or is heated, first leave the door ajar
for several minutes and then close.
Otherwise, expansion (pressure) may
cause the appliance door to spring
open or water to run out of the
appliance.
To continue the programme, switch
on the ON/OFF switch
Close the door.
Terminating the programme
(Reset)
Open the door.
Press START button
approx 3 sec.
on the digital display
Close the door.
The programme sequence lasts
approx. 1 min.
is indicated on the digital
display
(buzzer sounds).
8
Open the door.
Switch off ON/OFF switch
Close the door.
aus
.
1
.
1
again.
1
for
7
is indicated
.
8
.
1
15