Bosch SGS 09T06 Gebruiksaanwijzing - Pagina 20
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Bosch SGS 09T06. Bosch SGS 09T06 36 pagina's.
Pagina afdrukken
en
Programme data
The programme data (duration, energy
and water consumption) can be found in
the summary of instructions and refers to
standard conditions. Greater deviations
may be caused by:
different quantities of utensils
inlet temperature of the water
water pressure
ambient temperature
mains voltage tolerances
and appliance-specific tolerances
(e.g. temperature, water flow rate, etc.)
Only ranges can be indicated for the
automatic programmes.
The water consumption values refer
to water hardness value 4.
Selecting options/
standard settings
Operating principle
From the Main Menu you can select the
following options/settings by repeatedly
pressing the button M/OK
Timer programming
Remote Control **
Reduce Time
Onboard computer
Drying Level
Buzzer Volume
Adding Rinse Aid
Water Hardness
Interior light *
Language
Standard Programmes
Remote Setting **
** Only with installed
serve@Home interface
Within an option/basic setting there are
several possible settings that can be
selected using the buttons – or +
20
Downloaded from DishWasher-Manual.com Manuals
A selected setting is applied by
changing to the next option/basic
setting using the button M/OK
If a setting has been changed using the
buttons – or + and stored using M/OK
be displayed and the display returns
to the Main Menu.
Timer programming
You can delay the programme start by
24 hours in steps of 30 minutes.
If the option "Time Pre-select" is
chosen the display shows "Delay
start: 00 mins".
Set the desired time.
Return to the Main Menu by pressing
M/OK
programme by pressing the Start
Button
Close the door. This starts the time
counting backwards.
When the set time has elapsed the
programme will start automatically.
Until the programme starts you are able
to change the set time and programme.
:
2
To do this, use the button –
return to the Main Menu and change
the settings. Then start the programme
again.
In order to delete the pre-selected
time, set the time back to "Delay
start: 00 mins".
Remote Control **
After choosing the option "Remote
Control" the display will show
"Remote Control: On" (factory setting)
This can be deactivated by selecting
the "Remote control Off" option.
** Only with installed
serve@Home interface
.
3
, the message "Value Stored" will
2
and start the required
2
.
4
.
2
to
3