DRAGONFIRE CART Montage-instructies

Blader online of download pdf Montage-instructies voor {categorie_naam} DRAGONFIRE CART. DRAGONFIRE CART 2 pagina's.

California Proposition 65 Warning: This product can expose you to chemicals including Chromium (hexavalent

compounds), which are known to the State of California to cause cancer and birth defects or other reproductive harm.

For more information go to: www.P65Warnings.ca.gov.

COMPONENTS SUPPLIED (Refer to Schematic)

1 - Cart Base

2 - Left and Right Side Panels

3 - Back Panel

4 - (4) Casters

5 - Left and Right Doors

6 - Four Shelf Mounting Brackets

7 - Two Side Shelves

8 - Tank Interference Bar

9 - Tank Holder

10 - Front Door Support Beam

11 - Utensil Holders

12 - Door Handles & Shoulder Bolts

(16) 5/16" Hex Bolts & Lock Washers

(35) 1/2" Long (1/4x20) Hex/Phillips Head Screws

(4) Shelf Mounting Brackets

(8)Shoulder Bolts & Nylock Nuts for Shelves

You Will Need:

1/2" Wrench (Caster Bolts)

Phillips Head Screwdriver

3/8" Wrench

5/8" Wrench (Shoulder Bolts)

7/16" Wrench (Nylock Nuts for Shoulder Bolts)

GETTING STARTED

Unpack and layout all of the components and compare them to the schematic. Protective film is on most parts.

Unless it interferes with the assembly process, leave the film intact during the assembly process for protection and

remove when completed. The assembly process should be completed on a protective surface so the chance of

scratching is minimized.

To ease assembly, threaded screw inserts have been used throughout so nuts are NOT required to be installed.

Do not use power tools to tighten screws as they may damage these inserts. A Phillips screwdriver will ease the

threading and tightening of the Dual Head 1/2" Long Screws but we suggest using the correct size wrench for the

final tightening.

Step 1. Flip the Cart Base Panel upside down and install the (4) casters with the supplied 5/16" Hex Bolts

and Lock Washers. Tighten securely using a 1/2" wrench.

Step 2. Turn Cart Base right side up and install the Back Panel to the Base using (3) supplied 1/2" Long

(1/4" x 20") Hex/Phillips Head Screws. Hand tighten only at this point.

DRAGON FIRE CART

ASSEMBLY INSTRUCTIONS