Dragster DDM8000.1 Installatie- en bedieningshandleiding - Pagina 7
Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} Dragster DDM8000.1. Dragster DDM8000.1 8 pagina's.
Diagnost Guide
In the eventuality of any problems, the amplifi er will power down and the LED PROT (red) light will begin
to blink. Depending on the problem, the LED PROT (red) light will fl ash a certain number of ti mes. The
following table summarizes the diagnosti cs:
Number of Flashes
1
2
3
4
NOTE: In the event that the RED LED (PROT) light is fl ashing conti nuously, unplug the speakers and turn the
equipment back on. If the problem persists, contact tech support.
Warranty Information
Dragster Audio Art provides its products with the necessary technical support to replace components, as
well as the necessary work to repair any defects duly verifi ed as being from its manufacture, within the
warranty period and with their respecti ve invoice.
WARRANTY TERMS AND CONDITIONS:
The warranty provided is for 2 (two) years against manufacturing defects. Its validity starts on the date of
the invoice or, in case of warranty certi fi cate, the date when it was issued.
To make use of the benefi ts of this warranty, you must present one of the following documents: the invoice
or this certi fi cate dated and stamped by the retailer or installer.
CASES THAT VOID THE WARRANTY:
1. Problems identi fi ed aft er 2 years of the invoice or of the warranty certi fi cate (if completed) or 2 years
from date of manufacture, in case you don't havy any other document to prove when the product was
bougth.
2. Violati on of seals, alterati on or removal of the products serial or lot number.
3. If the product suff ers misuse, careless accidents involving liquids, fl ames, fall or if it was installed in
conditi ons contrary to the guidelines contained in the installati on manual that accompanies the product.
4. Damages and changes in the circuit or adaptati on of non-original parts.
IN CASE OF DOUBT OR IN ORDER TO ACCESS WARRANTY: www.dragsteraudio.it/contact
Problem
Output short circuit
or overload.
Overheati ng.
LOW
Low ba� ery.
BAT
Ba� ery overload or
voltage greater than
OVER
BAT
allowed.
Check to make sure the speaker cables
are pro-perly isolated.
Verify minimum impedance.
Make sure the equipment is installed in
a well venti lated locati on.
When used for long periods, the bat-
tery will run down. Recharge the bat-
tery.
Have the ba� ery and/or alternator
checked by a professional.
7
Soluti on