Electrolux # Gebruiks- en onderhoudshandleiding - Pagina 12

Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Electrolux #. Electrolux # 16 pagina's. Gas cooktop
Ook voor Electrolux #: Handleiding voor installatie-instructies (8 pagina's), Gebruiks- en onderhoudshandleiding (20 pagina's), Receptenboek (17 pagina's), Instructieboekje (12 pagina's), Gebruiks- en onderhoudshandleiding (20 pagina's), Instructieboek (16 pagina's), Instructieboek (12 pagina's), Insrtuctiehandleiding (16 pagina's), Gebruikershandleiding (11 pagina's), Gebruikershandleiding (9 pagina's), Gebruiks- en onderhoudshandleiding (16 pagina's), Gebruiks- en onderhoudshandleiding (16 pagina's), Gebruikershandleiding (16 pagina's)

Care an

Cleani

Cleaning cooktop, grates, caps and burner heads

Cleaning

the grates

The burner grates are dishwasher safe and may be

cleaned in the dishwasher. Remove any excessive

soils before placing in the dishwasher.

Your appliance is shipped with the burner heads

and burner caps in the correct locations. Before

using your gas appliance be sure to:

• Follow installation instructions before operating.

Remove all packing tape from cooktop area.

Caps

Should you ever need to remove the burner caps

for cleaning lift the burner cap off the burner

head. Clean heavy soils with an absorbent cloth.

Rinse with a clean, damp cloth and immediately

thoroughly dry including the bottom and inside

of the cap. Do not use harsh abrasive cleaners.

They can scratch the porcelain on the cap. Do not

clean burner caps in dishwasher. When placing the

burner caps, see Important note below.

Burner

heads

Lift the burner cap from the burner head. The

surface burner heads are secured to the cooktop

and must be cleaned

in place.

For proper gas flow it may be necessary to clean

the burner heads and slots. To clean, first use a

clean DAMP cloth to soak up any spills. Remove

any food from between the burner slots using a

small nonabrasive brush like a toothbrush and

afterwards wipe using a damp cloth. For stubborn

soils located in the slots, use a small-gauge wire or

needle to clean.

Should you experience ignition problems it may be

that an ignition port hole is partially blocked with

soil (see figure below). With the burner head in

place, use a small wire gauge needle or the end of

a paper clip to clear the ignition port or ports.

Slots

Ignition port

:)rifice port